Popular questions

If replacing the sensors did not fix the problem then you will need to have the wiring and computer pinpoint tests done to try and isolate the problem. The computer or wiring may be causing the problem and would need...

A possibility is a loose or missing oil fill cap and/or a large leak at the oil filter. There is a thick rubber ring gasket that seals the oil filter base to the engine. The gasket has to be applied...

Hello there, thanks for writing in. Many different faults can cause your 2002 Chevrolet Blazer to lose power. The most common would be spark plugs, wires, fuel pump, fuel filter, alternator, shift solenoid, low transmission fluid, or the battery. A...

This metal scraping noise may be inherent to the metal tube. The original tube was designed to be quiet and not be noisey when opening throttle. The noise is from air flow disruption through the air tube. The metal tubes...

You should have the A/C drains checked to see if the drains are blocked causing the water to leak into your 2008 Mercedes Benz R350. Dirt and debris that gets in the A/C evaporator case can clog the A/C drain...

Hi there. I have forwarded your inquiry to our sales professionals as this section is designed for automotive repair and maintenance recommendations. They'll be contacting you shortly.

The reason your heater was not working was because your engine did not have enough coolant in the engine to pump it into the heater system. You have overheated the motor now. You will need to find out when the...

It sounds like you may have a problem with one of your rear CV axles on your 2002 Honda Passport. If one of the axles fails, this can cause the driver to feel some resistance as well as vibrations. ...

Hi, to fix this problem you will need to replace the intake manifold gaskets. That will take care of the Barometric Pressure Sensor. I would inspect the exhaust gas recirculation (EGR) valve, since it may have been left open causing...

The fuel filters should of been filled before installation. You will need to bleed out all the air from the fuel system to get the vehicle to start. In the future you will need to fill filters before installation. This...

The brakes may not be releasing all the pressure if they are partly engaged after using them. This can be caused by a few different problems. Besides the brake calipers sticking or the brake hoses blocking pressure, you may have...

Hello. I would say you are on the right track. Another good sign that your power steering pump going out is a whine whenever you try to turn the steering wheel. Also, check the fluid level in your power steering...

Claimed by John Hege