Q: Where is the rear blower motor on a 2007 Honda Pilot located

This is a common problem with the Toyota 2AZ-FE engine. The bolts that are referenced are actually the cylinder head bolts. Due to a design flaw, the bolts strip out of the engine block, causing head gasket issues. Toyota released...

Having your car run fast like this sounds like a frustrating experience. Let us get you pointed in the right direction so you can drive your car worry-free. The symptom you are experiencing with your vehicle sounds like something called...

It sounds like your transmission (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-a-slipping-transmission) is either slipping in third gear or having trouble shifting to fourth gear. I would recommend having this issue diagnosed by a certified transmission mechanic, as soon as possible, as this could potentially cause...

Vibration at that speed is often related to the tires. It could be that one or more of the tires are out-of-balance, or that they have worn unevenly and now have a bad pattern worn into them. Vibration can also...

The first thing to check is the transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-is-leaking-inspection) level. If fluid level is okay, then the most likely problem causing a poor reverse engagement is low fluid pressure in the transmission. This could be caused by a worn...

Hi there. The synchronizer inside the transfer case has teeth that are ground down on the 2WD selection causing the transfer case not to engage into 2WD. I recommend seeking out a professional, such as one from Your Mechanic, to...

Hi There, This can be caused by a loose battery cable which is often times the problem. Try checking to be sure they are connected properly. Also, there is a sensor that has 3 small wires running to it that...

A blown head gasket may cause a number of different symptoms. A head gasket that fails between cylinders will generally cause a misfire and perhaps few other symptoms. A failure between cylinders will cause compression leaks from one cylinder into...

Hi there. The turn signals could be not working for an electrical issue in the circuitry from the switch to the system. Check to see if the hazards work on the vehicle. Even though the hazard switch is in a...