Q: where is the crankshaft sensor on an LDV Maxus 2008

asked by on December 26, 2016

I cannot find the cranksharf sensor on my LDV Maxus van 2008

Hi there:

Unfortunately, we don’t service commercial vehicles like the LDV Service van you’re referring to in this inquiry. You might want to contact LDV service department to receive a schematic for your vehicle.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

Leaking coolant - 2004 Chevrolet Silverado

Hi there. Depending on what edition of the Silverado you have the leaking coolant may be coming from the radiator overflow reservoir. It might also be a heater bypass tube that's damaged. The reservoir is used for overflow, as coolant...

Why are my wipers going off when I turn the turn signals on?

Hi, thanks for writing in. It appears that there may be an issue within the column. The controls for the wipers and turn signals are separate units, but are connected by a series of wiring within the column, and there...

Engine cutting off

This is a sign of a failing or dirty mass air flow sensor. The mass air flow sensor is a unit in the intake system that monitors air intake as it is mixed with fuel prior to being injected into...

Car going forward in reverse

I am assuming this is an automatic transmission in your Celica. There are a couple of possibilities. There is a park/Neutral Position switch on the side of the transaxle that if faulty can cause the incorrect solenoids in the transmission...

2007 Nissan Altima motor mounts are new the motor vibrates a lot went the car is in drive with the ac on went I turn the ac off it

Hi there. It is possible that you have a vacuum leak or perhaps the transmission mounts are loose, as usually these symptoms are common with worn out motor mounts. When the AC is activated, it does create additional drag on...

How do I turn on the daytime running lights?

The daytime running lights are low-power lights that can be useful to use during daytime driving, and will automatically adjust depending on how dark it is outside. To turn them on, rotate the light switch (located on the turn signal...

Won't start with good battery

The computer in this car controls if the starter turns or not. You will need to have the computer scanned to see if the alarm is active. Have the batteries changed in the remote key FOB to see if this...

Ac clutch blowing fuse

The AC would have to be diagnosed to see if the clutch or compressor is blowing the fuses. You could try disconnecting the compressor to see if the AC is still blowing fuses. If it does, then further diagnostics would...

The first pump was no good! Now you send the wrong pump?

Claimed by Tim Charlet

Related articles

Kansas Parking Laws: Understanding the Basics
Kansas Kansas drivers are responsible for parking properly and abiding by the laws. They also need to ensure that their vehicle does not become a hazard when it is parked. There are a number of laws in the state that...
Symptoms of a Bad or Failing Wheel Stud
Common signs include damaged threads on the wheel stud due to improper installation of the lug nuts onto the stud and rust on the wheel stud.
P0838 OBD-II Trouble Code: Four Wheel Drive (4WD) Switch Circuit Low
P0838 means there is a circuit issue with the four wheel drive switch, most likely due to a failing actuator or switch.