Q: What does the speedometer show?

Hello and thank you for contacting YouMechanic. When you unplug the temperature sending unit the problem goes away but the engine light comes on. Check the plug to the sending unit for any corrosion or debris. Look at the pins...

Hello. If the vehicle overheated to the point where steam started to escape, you are better off replacing the engine altogether. Once the cooling system is filled with water, it can be pressure tested to see if there are still...

If the vehicle does not crank after running the battery down, this can cause the anti-theft system to engage and may need to have the system reprogrammed to work again. Look at the dash when you try to start the...

Hello, thank you for writing in. When your wheels are turned all the way (also known as "clock to clock") there are rubber stops that will protect the wheels from running into body or frame. When the wheels hit this...

Hi there. If you are referring to the distributor rotor, it is best to only use the same rotor for each individual vehicle. Although the engine size might be similar between those two vehicles, the ignition system has minor differences;...

Hi there - this is a problem with this engine, and the stock exhaust manifolds come with heat shields to help prevent the burned plug wire problem. Perhaps your heat shields have been removed? Or, if you're running headers, using...

Hi There, The jerking or bucking (https://www.yourmechanic.com/services/car-jerks-forward-at-high-speeds-inspection) problem you describe is normally associated with either transmission problems or some kind of misfire related to ignition problems (i.e. crank sensor, cam sensor, ignition coils, bad spark plug wires or plugs) or...

Hi there. With the CVT system, there could be multiple internal transmission components or sensors that are causing this type of problem. However, it's also possible that simply flushing the transmission fluid and changing the filter would resolve this problem....

You were probably right to change the plugs and coils, they needed to be ruled out. But since you're not getting codes for a specific cylinder, your problem is probably a little more subtle. You might be having a problem...