Q: cost please.. asked by Marc H on December 22, 2016 How much time does it take your mechanic to change A Mass Air Flow, and fo

Hi, I have read articles that would indicate that Ford has a TSB (Technical Service Bulletin) for that year's model and for the lower control arm and several people are having the same problem. I would take it to the...

This sounds like there could possibly be a vacuum leak somewhere. My other guess is that the new idle air control valve may also be malfunctioning. If you switched out some parts lately, getting new car parts that are bad...

If you are hearing noise from the front wheel bearings, then you will have a noise that will get louder the faster you go. The noise may get more or less as you turn the wheel left or right. Have...

Hi there. There are a few different things that can cause this. Most of the time though, this is caused by an issue with the TCM or a power issue to the TCM. I usually start by testing the ignition...

Hello, thanks for writing in about your Ford F-100. Depending on the engine you have and if you have a manual transmission then you may have broken motor (https://www.yourmechanic.com/services/engine-mount-replacement) and transmission mounts that will cause the clutch linkage and shifter...

This may be a sign of warped brake rotors and/or potentially failing wheel bearings. When your brake rotors get hot due to the heat caused by friction, they can develop hot spots in them which causes an uneven surface area....

Hi there. The codes are coming up for the camshaft position sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement), Oxygen sensor (https://www.yourmechanic.com/services/oxygen-sensor-replacement), EGR valve (https://www.yourmechanic.com/services/exhaust-gas-recirculation-egr-valve-replacement), and evaporative (https://www.yourmechanic.com/services/canister-purge-solenoid-replacement) system not working. The fuses for EMS1 and EMS2 and the main relay vary depending on what Aveo...

Typically, on this engine there will be a blockage, consisting of hard packed carbon, in the passageway in the plenum. It can be very difficult to clean out those passageways on the vehicle without removing the aluminum plenum for a...

Hello - the required maintenance depends on which problem code is setting off the Check Engine light, and what the other symptoms are. A throttle position sensor failure will cause different behavior (and set different codes) than will a dirty...