Q: No power to vehicle

asked by on

I have no power to my vehicle whatsoever. A multimeter test is showing my battery as being good though.

The battery and starting system would need to be checked to see if the battery or the cables are a problem. The charging system would need to be checked also. I recommend having a certified mechanic, like one from YourMechanic, come check your vehicle’s loss of power and perform the needed repairs for your car.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. No power to vehicle

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: How can I get in my trunk through the back seat?

Hello. Accessing the trunk from the back seat will require removal of the seat and part of the side panel. If you have the owners manual, it will likely have more information on this. There are a set of screws...

Q: Battery saver mode came on again?

Hi there. Check the battery cables and make sure that they are tight and clean. Check the wires on the alternator and make sure that they are clean and tight. Check the ground circuit on the fuse box and insure...

Q: I need to install a new powertrain control module.

Your new module will need to be programmed with your VIN and a dealer pin number to get the anti-thief system to work properly. A DRB3 or STAR scanner is necessary to get this done.

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...