Q: My 83 Jeep CJ 7 makes a clunking on rapid acceleration only when in 4 wheel drive. Any thoughts on my problem?

asked by on September 17, 2017

only when in 4 wheel drive, there is a big clanking noise when I accelerate hard. It doesn't happen if I accelerate slow. Any feedback or advice?

My car has 115000 miles.
My car has a manual transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Coolant leaking from engine head gasket
Head gaskets can leak in several ways. It can be an external coolant or oil leak, coolant can leak into the combustion chamber and vise versa, and coolant can leak into the oil. This is not a repair to delay....
My car will not start. I changed the head gasket an now it will not start.
If your car was not running and a computer update got it running but the engine would shut off so you did a tuneup, brakes and a head gasket. You might have problems with the installation of the head gasket...
Trunk will not open
I think it is possible that you may have shut an object of some kind in between the trunk latch and the trunk lid when you shut the trunk. If an object becomes lodged in the correct spot, this can...
Radio stays on after key is removed and car exited
Hello. If this is the factory radio then you more than likely have an issue with the retained accessory power system. This is what allows the system to retain power when the key is off until the door is open....
Car is in limp mode and making strange sound when beginning to rev.
Hi there: When the oxygen sensors have a reading that is similar to each other, it is an indication that the catalytic converter is not working as efficiently as it is intended. If the voltage of the downstream oxygen sensor...
Procedure to replace lower ball joints and sway bar links and torque specification for all the front end components
Hi there. To replace the ball joints you would need to jack up the vehicle and put it on jack stands. Remove the tires, calipers, and brake rotors. Then put a jack under the lower control arm and remove the...
How long does it take to replace valve stems? 1999 Chevrolet Silverado
Hi there - unfortunately, this is a task that needs to be done by your local tire service center. To replace the valve stems requires dismounting, then re-mounting each tire, replacing the valve stem while the tire is removed. Thanks...
I have a 2001 BMW 325i. It overheated, engine shut down. When cooled down (24 hours), while water poured in the reservoir I could
I'm not clear on where you see your leak, but if it is in the radiator tank itself, that will mean you at least need a radiator. If the car ran hot until it shut off, there may have been...
Idler pulley broke off metal it was attached to after results from a crooked pulley and multiple serpentine belt slips.
You're right in that the stress will be too great and it will come apart again. This is not something you can fix with glue. You will need to take off all of the broken parts and replace them with...

Related articles

A Buyer’s Guide to the 2012 Jeep Grand Cherokee
Though Though the Jeep Grand Cherokee is not a new model, it got a complete redesign in 2011, and the 2012 Jeep Grand Cherokee saw even more improvements. While other SUV manufacturers have sat on their laurels, Jeep has done...
The Best Used Cars to Buy If You’re a Photographer
If If you are a photographer, and you’re considering buying a used car, the big thing to consider is the type of photography you do. Thanks to the advances in digital photography, chances are you’re not hauling around a lot...
The Most and Least Expensive Cars to Insure
Car insurance quotes depend on the car make and model. The Honda Odyssey is the least expensive and the Dodge Viper is the most expensive to insure.