The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
If the pump is losing its pressure, then output could be the cause of the steering and noise issue. You would need to have the power steering pump tested to make sure the pump is supplying the proper pressure in...
Hi there. You should check to see if the fuel pump is turning on when it will not start. This can be done by checking fuel rail pressure or listening for the fuel pump to make noise when you turn...
Steering wheel vibration during turns might be an outer constant velocity joint (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement). The mechanic can check general condition of the engine, even if the engine noises are not present when the vehicle is checked. Check aftermarket automotive suppliers for...
Hello and thank you for contacting YourMechanic. The 4L60E has electronic shift solenoids that shift the transmission in first, second, and fourth. If you unplug the harness to the transmission, your transmission will only have reverse and third gear. In...
Hello. To answer your location question, the ECM is behind the fuse and relay block of electronics under the passenger side of the dash (behind the glove box). The ECM is behind the other electronics, mounted flat against the firewall,...
You are hearing the brake pads moving up and back in the caliper bracket. This is caused by the front rotors being warped, and it is also possible that the pads' anti-rattle clips were not installed correctly. The rotors should...
Hi There, Code P1381 is related to the crankshaft position sensor malfunctioning. The crankshaft position sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) is an electronic device used to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems...
Hi there. It sounds like there is junk in the fuel system from running the vehicle out of gas. I recommend putting in a fuel treatment in the fuel tank and letting it sit for about 1 hour. This will...
Hi there. You will most likely have difficulty with compatibility with these two years of Camaro. Although they might physically fit inside, they would probably require fabrication of the seat mounts to work correctly.
An An axle seal is the part of the vehicle that connects the axle to the rear differential, or the transmission. The purpose of the axle seal is to keep transmission fluid from leaking. Depending on the size of the...