Q: interior lights

Yes, but only if the leak is large and sudden. Such leaks are typically due to a blown steel brake line (https://www.yourmechanic.com/article/what-can-cause-brake-fluid-to-leak-from-the-brake-system) (due to rust) or a blown rubber hose. Even in the event of a large leak, in a...

When you are looking at the question of whether you should rebuild or replace a motor, you will first have to assume the original motor is rebuildable. If you do not know if your engine is rebuildable then the engine...

Your car is automatically set to display information in English in the message center. However, if English isn’t your preferred language, you can change it to another option. Here’s how to do that: Cycle through your options until you see...

Hi there. This can be a couple of somewhat easy issues to fix. Your vehicle sounds as if it is experiencing a common side effect of a dead battery. Secondly, your vehicle alternator possibly is not outputting enough power to...

Hello! They added metallic brakes on the front to give the front more stopping power than the rear, which is great for stopping during sudden braking. It will be beneficial to put slotted rotors and performance pads on the van,...

Hello there, thank you for asking about your 2003 Ford Taurus. Your fuel pump in the fuel tank is most likely going bad and will seize up when it gets hot. Have the fuel pressure tested to see if you...

Hi there. The codes P0012 (https://www.yourmechanic.com/article/p0012-obd-ii-trouble-code-camshaft-position-a-timing-over-retarded-bank-1-by-jay-safford) and P0015 (https://www.yourmechanic.com/article/p0015-obd-ii-trouble-code-camshaft-position-b-timing-over-retarded-bank-1-by-jay-safford) are related to the camshaft position sensor. Check the sensor out and make sure that its plugged in. Also, check for power to the sensor. The camshaft sensor keeps the ignition...

Hi there. Typically when you don't have a fuel or ignition system component failure, a vacuum leak or loose motor mounts will be the source of this type of vibration. If you're having this vibration all the time, I would...

Hi Amber. Thanks for contacting us today. Usually a whining noise while turning is an indication of either worn wheel bearings or low power steering fluid. It is also possible that a steering suspension component might be loose or worn,...