Skip the auto shop - Our mechanics make house calls

Q: I need a motor mount car shaking pretty bad

asked by on

Would I be able to put the motor mount in by my self? Do you need a cherry picker? Is it something I really should have done by a mechanic?

My car has 90000 miles.
My car has a manual transmission.

Depending on the motor you have you may have to support the motor and at the same time lower sub frame to replace the motor mounts. I would recommend getting a mechanic with the capability to replace your motor mounts. It may require a vehicle lift and a sub frame support lift.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. I need a motor mount car shaking pretty bad

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: At a dead stop you can floor it and it moves the shifter into neutral on its own.

Hi there. Check the engine and transmission mounts and see if they are allowing the transmission to move around. It is possible that the transmission is moving around and catching the shifter linkage and pushing it into a neutral position....

Q: Navigation screen system says "program cannot be read" after new car battery was put in.

Hi there. You will need to do a hard reset on the vehicle if your navigation system is factory in design. Disconnect the battery and turn the headlights on. Hold your foot on the brake pedal for 1 minute and...

Q: I need to know where the fuel cut off switch is at

An auto fuel cutoff switch is a safety feature that is only supposed to activate in a collision. If you merely ran out of gas, or ran low on gas, the status of this switch is probably irrelevant. Nevertheless, if...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...