All my trouble and warning lights come on . Car runs good


All my trouble and warning lights come on . Car runs good Mechanic's Assistant: Just to clarify, what are the exact lights you're talking about? Abs, steering, traction control, engine hill start, Mechanic's Assistant...

All my trouble and warning lights come on . Car runs good Mechanic's Assistant: Just to clarify, what are the exact lights you're talking about? Abs, steering, traction control, engine hill start, Mechanic's Assistant: What is the make/model/year of your car? 2017 Honda [Pilot](/topics-pilot/) Mechanic's Assistant: Are you fixing your Pilot yourself? What have you tried so far? I disconnect the battery. Reconnect it lights went off. Came on a day latter

Automotive Expert
Hello and thank you for using JustAnswer. My name is \*\*\*\*\* \*\*\*\*\* I will do my best to assist you.. I help many customers, so sometimes my replies are delayed, I will respond once available. During this conversation you will be given an automated offer for a phone call. You may accept or decline that offer.I don’t personally offer this service so if you take this another tech may call. These lights will come on when the computer sees a problem that affects the performance of the abs system. There are many problems that can fail that will trigger this. It could be a faulty sensor, wiring issue, module fault, etc. To see what specifically is causing the light to come on the vehicle will need to be tested with a scan tool that connects to the vehicle. This test will provide a trouble code that describes what specific system is having the problem. If you can have the vehicle scanned and can give me the code, I will be able to tell you specifically what is wrong with it. If you do not have a scan tool then you can bring your vehicle to any auto part store and they will scan it for free and give you the trouble code. I would do this ASAP so that we can determine what the problem is and keep any other problems from happening.

What others are asking

Vibration when changing gears.
Vibration between shifts in an automatic or manual are pretty similar and are usually caused by loose motor or transmission mounts, but could be mimicked by suspension components. Have a mechanic from YourMechanic inspect your vehicle (https://www.yourmechanic.com/services/car-is-shaking-or-vibrating-inspection) for any looseness...
Key turning effortlessly and not starting car
I think you are exactly right. The tumblers inside your ignition lock cylinder may be broken as they are usually what locks your key into each position such as accessory, on, or run. Also, if the car will not start,...
New clutch but vehicle just revs when put into gear
Hey there. The clutch is self-adjusting and after service the pedal should be pressed five times to set the pedal free travel. If the clutch still does not engage then you may have a defective clutch pressure plate if the...
Ignition fuse keeps blowing
You had a good start by tracing the wires and making sure they were clean, dry, and not damaged. To make sure you covered the entire circuit, I recommend you use an official wiring diagram to check this. It is...
Car make comparison
Hi there: Among the list of brands you listed, none of them are really known for having major problems in recent years. In regards to overall reliability, cost to maintain and durability, Nissan tends to be the most consistent of...
Every time I droves 40 or 50 and apply to the brakes,my front end shakes what can this be
The most common cause for a pulsation when the brakes are applied is warped rotors. The brake rotors will wear over time and the brake rotors are a perishable item. The rotors can warp due to excessive wear, using the...
Engine stalls sometimes but not all the time
Hello, Unfortunately, without additional information as to the make, model and year of your motorcycle it may not be possible to suggest what may be causing it to stall. Depending on whether or not it is fuel injected, or not...
I have a dodge nitro 2011 , which gas should I use 95 or 91 octane? 2011 Dodge Nitro
Hi there - based on the Owners Manual (Pg. 351-353), the 3.7 L engine requires 87 octane, and the 4.0 L engine requires 89 octane. The manual also cautions against using higher octane fuel than required, as this provides no...
When my alternator went out, could it have killed my battery?
Hello, thank you for writing in. The symptoms you are having are classic of a failing alternator. While the battery can be damaged and fail due to the vehicle relying solely on it for power while running, you will want...