I have a 2013 honda accord and this week the eps light ab...


I have a 2013 honda accord and this week the eps light abs light and low tire pressure light came on at the same time but doesn't stay on. Mechanic's Assistant: Have you checked your tire pressure? Do you have a tire gauge...

I have a 2013 honda accord and this week the eps light abs light and low tire pressure light came on at the same time but doesn't stay on. Mechanic's Assistant: Have you checked your tire pressure? Do you have a tire gauge? Yea and it is 32 psi Mechanic's Assistant: Are you fixing your Accord yourself? What have you tried so far? If I can yes but if not then I will take it somewhere Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? That is all

Automotive Expert
Hi! This is Anthony, a Honda master technician here on Just Answer. Sorry to see you’re having trouble with your Accord. With whom do I have the pleasure of speaking with today?

Hi my name is Tiffany.
Automotive Expert
Hi and you would need to have the cars abs system scanned. You must likely have a abs sensor or the abs control valve going bad

Yea it would come on then cut off now all 3 lights are on all the time
Automotive Expert
Correct. They will start to stay on all the time now

since the car has a electric power steering it dont take power steering fluid right
Automotive Expert
Correct

Ok so since the light is on means my pump is bad
Automotive Expert
No, you have electric powering steering which means you have a motor. Your issue is a bad ABS sensor or VSA module. You would need to have the car scanned for codes to tell you exactly which one is bad. All these lights are related to one of the two issues I mentioned.

What others are asking

Can I Let the Washer Fluid Reservoir Run Dry?
It is best to keep any fluid system in your car from running dry. The washer system often sits unused, so it can be easily forgotten. When the fierce winter weather is upon us, it is easy to think of...
Gear shift lever stuck in Park
This is a very common problem for your type of vehicle. Oftentimes, there is a component in the shifter mechanism that fails, and causes the shifter to be unable to come out of park. The repair for this is to...
Brake booster signal failure
It is possible that your master cylinder may be failing (https://www.yourmechanic.com/services/brake-master-cylinder-replacement) on your 2014 Dodge Dart. The master cylinder can be full and still cause issues. If the internal seals inside the master cylinder begin to fail, they will allow...
Rim swap Ford Expedition and Dodge Ram
That is hard to tell without looking at the rim and the truck you want to install it on. It should fit but there is no gaurantee that the backspacing is correct. Try looking up the wheel manufacturer and see...
Have a jeep grand cherokee it cranks but has no spark started a few times then nothing what sensor went bad
There could be a bad cam sensor, crank sensor, coil, or even a wiring issue. It would be best to test the components individually to determine which is causing the problem. My recommendation would be to connect a diagnostic scanner...
i have a 2005 gmc c5500 the heater motor comes on for 20 sec when first start truck then nothing
Hello - I suspect this may be a problem with the fan motor resistor pack. If the fan control is put in the "Max" or "High" speed position, does the fan continue to run? Does the fan only run for...
Stalls and stutters only in the morning when I start it
As a general rule, car engines do not like cold weather and do not do operate as well in cold weather. When you start your car in the morning and turn the key to on, the coolant temperature sensor immediately...
Do you know where the horn relay is located in a 1997 Honda Odyssey?
Hello, thank you for writing in. The main fuse box which houses the horn relay is under the hood to the left (passenger) side of the vehicle. When you remove the lid to the fuse box, turn it over and...