Q: Erratic Idle

asked by on

car has an irregular idle where it jumps 200 to 300 rpm constantly ( at idle) and sometimes cuts out at red lights. Its a Diesel C220 2008 W204 Automatic Mercedes Benz

My car has 85000 miles.
My car has an automatic transmission.

Hello! It sounds like you may have a dirty or faulty idle air control valve. The idle air control valve monitors the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at idle. This valve is controlled by the vehicle’s computer and will adjust idle speed based upon other measurements such as engine temperature, intake air temperature and electrical system load or voltage. This is also an important function when starting the motor as it allows the motor to run and idle on it’s own once the motor fires. When you accelerate, the engine RPM increases, and as you let off the gas, the RPM slowly returns to the normal idling speed with the help of the idle air control valve making the transition from a higher RPM back down to idle speed while adjusting the air/fuel ratio constantly to allow this to happen smoothly. When the engine RPM drops below the normal range of about ~800 RPM, this often times will cause the engine to stall indicating a dirty or faulty idle air control valve. I would recommend having an expert from YourMechanic come to your location to diagnose and replace your idle air control valve.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Erratic Idle

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Q: High idle problem.

This may be a sign of a vacuum leak. A vacuum leak can be one of the most frustrating and difficult problems to diagnose. High idle speed is a common sign and stalling is another. Confirmation of an engine vacuum...

Q: Q: Where is the crankshaft position sensor location?

The crankshaft position sensor is located on the driver side of the engine and in the back by the transmission on the engine. If you need further assistance with your crankshaft position sensor, then seek out a professional, such as...

Q: 2054 fault code

Hello. The code you are getting is for what is known as the PremAir sensor. This is the ozone air detection sensor. They are a common failure on this vehicle. The sensor can usually be tested with a scan tool...

Related articles

How to Avoid Back Pain in a Car
If you have back problems, sitting in a car for an extended period of time can be excruciating. Even without back problems, you could experience discomfort and soreness from...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
How Much Does a Mechanic Make in Vermont?
Automotive technician jobs in Vermont have an average mechanic salary of $37k, with some mechanics earning a salary of $53k.