Skip the auto shop - Our mechanics make house calls

Q: Alignment off on 2004 GMC Envoy

asked by on

The alignment went out on my car.

Hello. Sometimes hitting a curb or running over a pothole can cause the alignment to go out in a car. Also, if you have a worn suspension it will cause the alignment to go out as well. If this is the case, a shop with a wheel alignment machine will fix the problem. There are several suspension parts that could be worn and would need to be inspected. These parts include: inner and outer tire rods, upper and lower control arms, ball joints, and struts. To rule out that there’s a problem with the suspension, I would suggest having a certified technician, like one from YourMechanic, inspect your suspension.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: camshaft position sensor is bad

Bank 1 normally refers to the side of the engine that the number one cylinder is located. However, since your vehicle has an inline six cylinder engine, you will only have one bank. Therefore, your engine should only have one...

Q: Alignment - 2007 Lincoln MKX

For an alignment to be as precise as possible, the used tires on the car have to have reasonably uniform wear. The best alignment results will be obtained with new tires, but so long as the tires that you have...

Q: No power to most fuses , truck runs very rough

Hi. Fuses tend to break when there is too much power being flowed through them. However, since you have power running to the motor, this could indicate a problem with the fuse box itself or perhaps a main relay. Without...

Related articles

Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.