Showing articles & questions for topic
Rabbit

It sounds like you have a misfire or low fuel pressure. You should have the computer checked for misfire or other codes and check fuel pressure to see which one is causing the problem. A mechanic like one from YourMechanic...

Hi there. Check the engine and transmission mounts on your vehicle. When accelerating quickly, the engine and transmission move around causing the loose or broken mounts to make the engine and transmission move around violently making the front tires to...

This code is related to the catalytic converter (https://www.yourmechanic.com/services/catalytic-converter-replacement). As you may know, the catalytic converter is a section of your exhaust system that helps to complete the combustion process when excess unburnt fuel gases pass through the exhaust. Due...

Hello. It sounds like the alternator has failed (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-alternator) and is not charging the battery. The purpose of the alternator is to take over for the battery once the car has started. If the alternator is not working properly, then...

I have seen people seal their sun roofs with a clear vinyl cover (decal type). I would try to find a business that makes vinyl wraps for cars or boats and talk to them. Also, check the fuses for the...

There is a fault with the latch and/or the cable actuator. Hood misalignment, if severe, can cause this issue as well. The whole latch assembly and mechanism should be inspected for damage, cleaned and lubricated to resolve this. If you...

Hello, thank you for writing in. The vehicle does utilize a lot of the same sensors for these systems. Are there any other codes that are coming up when this code appears? If so you will want to take these...

Hello. Even though the battery has been tested, there still may be a problem with the battery or alternator (https://www.yourmechanic.com/article/alternator-or-car-battery-how-to-tell-which-part-is-the-problem) not charging properly if the car needs to be jump started. The factory alarm is very hard to disable and...

Hello. It sounds like the PCM (powertrain control module) and the BCM (body control module) have malfunctioned because of a shortage in the battery system. This could have happened when the battery failed, was removed, or installed. One explanation for...

Hi. The sensor is most likely broken and needs to be replaced. You can get rid of the warning light by unplugging the sensor until you get a replacement. The way the circuit works is when the hood is open,...