Popular questions

There are several things that may be causing this problem. Firstly, dirt stuck in the rails of the sun roof can jam or impede the full range of the motion of the automated top. Also, if any of the components...

Engine braking is the process of using the engine to slow the vehicle down instead of using the vehicle brakes. Engine braking can be used on both gas or diesel engines and is used to slow a vehicle down or...

The gas pedal is broken in your car. I recommend replacing the gas pedal and the throttle pedal position sensor on the gas pedal if the new pedal does not come with a new sensor. The gas pedal has a...

Hi Jacki. Thanks for contacting us today. The Stepper Motor is a component that is found within the CVT transmission valve body. It should be replaced as a unit - not the individual unit - as it's very difficult to...

Hello. A rattling noise during turns can be caused by many things. If you suspect the noise sounds like a pebble rattle it may be possible that there is one stuck somewhere, perhaps in between the vehicle's wheel well covers,...

My diagnosis would depend on whether the Battery Light illuminated before the engine died, or if the engine died before the Battery Light illuminated. If the Battery Light illuminated before the engine died, then you most likely have an...

Load test the smaller 12 volt battery, that is located in the rear right trunk area. Of course, be sure that 12 volt battery is properly connected, too, as it might have been disabled during the high voltage battery replacement....

If you are getting a noise before you start the car, at the moment you are getting in, then this is due to the suspension of the right front. The movement of the suspension and a squeak is most likely...

The clutch is burning up due to slip of the clutch overheating the clutch and melting the rubber. The reason it is slipping is the compressor locking up at the higher RPMs. You will need to reclaim the A/C refrigerant...

This engine uses a timing belt and not a timing chain.

The code is for the oil pressure is low or the pressure sensor is open circuit. This will cause the failure low power mode. I suggest having the oil pressure checked and if okay then replace pressure sensor to fix...

The clock can be turned on or off easily and quickly: 1. Press the Trip Computer switch until the settings menu shows up 2. Rotate the Trip Computer switch to Clock, then press the switch. 3. Rotate the Trip Computer...

Just to replace the spark plugs is going to require about 2.5 hours to remove the upper intake manifold and all the coils to access the spark plugs. If doing the job for a misfire then be prepared to replace...

If you no longer use a garage door or need to add in a new door and the spaces are all full, you may have to erase the memory of HomeLink. Press the two outside buttons on HomeLink and...

Prior to replacing the whole engine, you should obtain a diagnosis of both the loss of power issue and the noise. There are some noises that originate from accessories and there are also noises from the valve train and repair...

A number of things things may affect the alternator not pushing current to the battery. The main feed wire to the battery is protected by a series "fusible links" in the line from the alternator through the junction box, to...

I would definitely not recommend to drive the vehicle in its current condition I would recommend having the gas tank replaced completely not just cleaned. It would be nearly impossible to get all of the rocks out of the tank...

The code P0442 is the computer has detected a small leak in the evaporative system. You may have a leak in the seal of the fuel cap, pressure sensor leak or defective sensor, vapor valves or lines leaking slightly. You...

The roof rack adds a lot of extra storage to your vehicle. With the roof rack attached, you can carry items on the roof of your car. The roof rack has four positions that the roof rack cross rails can...

The two engines you cite use completely different computers (PCM/ECM) and the casting numbers are completely different. You can try it but you are all but guaranteed to have start up and operational problems due to incompatibility with the existing...

Hi there. What you are describing is common with oil distribution or lubrication issues on top of the cylinder heads in most cases. It can also be an indication of loose cylinder head hardware, such as valve lifters that are...

Hey there. The temperature blend door on the left side is not switching from cold to warm. The temperature actuator needs to be replaced and the linkage checked. Have a local expert inspect the cooling system to verify these issues...

This sounds like a potential problem with the charging system. The primary function of the battery is to start the vehicle. Once it is running, the alternator provides all electrical power for the vehicle. However, the battery does function as...

Hello. The power steering pump, power steering lines, and/or steering gear could be faulty or have a leak. The problem you are having with your accelerator pedal being hard to press could be due to a throttle cable that is...