Popular questions

A failed alternator is a possibility, and is among the components that would be checked first, but it is not the only possibility. Charging system output should be verified against factory specifications. To have the alternator inspected and replaced, if...

Hello. This is a common problem with 2003 Honda vehicles. The wafers in the ignition switch/cylinder are getting stuck in the cylinder, which is causing it to not turn when the key is in it. The ignition switch cylinder will...

It is possible that your engine could have a fuel issue of some kind. Considering that it is a hybrid, I would not overlook they electric motor for issues during this diagnosis. I would first recommend having your vehicle scanned...

Do not try and start the vehicle. Contact your insurance company. Have the vehicle towed out of the water. Have the engine checked by removing and cleaning out the air intake, clearing the engine of water by removing all spark...

If you smell antifreeze inside of your truck then it may indeed be the heater core. Most of the time the passenger side floor will also get wet from antifreeze if there is a leak in the core. A leak...

A cooling system pressure test using dedicated equipment will be able to pinpoint the location of your coolant leak. Running a vehicle low on coolant can cause it to overheat, resulting in extensive engine damage. My best advise is to...

Hello. It sounds like your AC compressor may have failed. If the compressor fails internally it will lock up and cause the belt to squeal and make this noise. The compressor can also release oil when it fails. I would...

You may be experiencing the symptoms of a recall campaign that Nissan has out for a faulty positive battery terminal; this condition can cause a hard start, or cause the vehicle to stall unexpectedly. If you are unsure whether this...

First, verify the fuel tank is not empty. If you have fuel and the fuel gauge and pump is inoperative, then you may have a bad fuel pump and connector to the fuel pump. If you are still having trouble,...

Suspension systems and the angles of wheels are engineered to work together for optimal performance and to minimize tire wear. It has become increasingly popular among the “tuner” scene to achieve the look of maxed camber, as the wheels visually...

I would recommend replace the starter first since there are issues with it and a bench test only checks to see if it turns and does not test the drive gear. Replace starter and go from there.

Hi and thanks for contacting Your Mechanic. Since the problem started when you had replaced the battery, check the wires to the battery and make sure that they are not corroded. Also, check the battery cables for they are on...

The oil light will come on if the oil pressure drops too low for adequate lubrication of moving parts in the engine. If the light does come on, you should quickly shut off the engine, but only once you are...

It is possible that your oil ring could be faulty in the number eight cylinder. If the oil ring is faulty, this can allow oil to get past the piston into the combustion chamber and therefore causing it to get...

Hi. The automatic tensioner in your vehicle is a one piece design. It comes mounted onto a bracket, if it is replaced completely. It is possible to only replace the pulley and bearing, but if the issue is with the...

Headlights are relatively simple circuits. You will want to check all components from the switch to the bulb. To perform these tests, you will need to have a voltmeter and understand how to use it. You will test for available...

Sounds to me that there is an issue with your slave cylinder. If it has a leak, either internally or externally, it will cause the clutch not to disengage. This can be determined by a mechanic who can inspect your...

I would recommend taking the vehicle back to the facility that replaced your TPS and ensure that the throttle body gasket was replaced as well. If the gasket was not replaced a vacuum leak may exist near your throttle body...

Hello. If coolant is not reaching the radiator, it is an indication that the coolant is not moving through the system properly. This could be caused by an air pocket in the system or a clogged hose. Another possibility could...

Hello. There are several things that could cause that heater to not work properly and the fan to only blow air on high. It is possible that you have a bad thermostat, which would cause the lack of heat. It...

Hello. This problem could be caused by several different things. You could be out of gas, the fuel pump might be working properly, the timing belt could be broken, there could be an issue with electricity getting to your spark...

If there is fluid coming from the slave cylinder then that needs to be replaced. A slave cylinder can fail if the clutch is worn out as it will need to work harder. I would typically start with repairing any...

There are many reasons why the AC would only blow hot air in your car. The most common would be a pressure switch or low refrigerant. Over time the refrigerant will leak out and once it is low enough it...