Popular questions

Question
Car has a little trouble starting but starts. While driving sometimes the lights will dim or my radio will cut off then back on.
Make sure you have good battery cables and battery terminals as well. Check for any fine cracks on the terminals, which can lead to a loose connection. A faulted sensor like a coolant sensor or air temperature sensor can offer...
Question
Engine lost power and EPC light came on
Hello. If the dealership follows the proper rebuild procedures there should be no real cause for concern, however there are a few things you can do to protect yourself from a repeat failure. Primarily, you can choose to have the...
Question
I need help locating my starter
Replacing the starter can be a bit of a tricky job as it is located usually down on the driver's side of the motor underneath the exhaust manifold on the side of the engine block. It is mounted very close...
Question
What is the required mileage before oil change
If you use the recommended 5w30 oil with an oil change interval of 3000 miles you will be doing the oil changes as recommended for severe use. You can choose to do the changes later up to 7500 miles if...
Question
I hear a clicking sound when I turn left.
It sounds like you may have a bad cv joint. I would recommend having a YourMechanic technician come out and diagnose the clicking noise and they can install a new cv joint one as well if that is in fact...
Question
1.Van shakes only when backing up. 2. While driving, van will not change gears.
Hi Arthur. Thanks for contacting us today. One thing that could cause both of these issues is a blown or leaking inner transmission seal. Since the automatic transmission works as a hydraulic unit, any leaks can cause inconsistent operation of...
Question
I have a 1997 Nissan Maxima GLE and I have no presser on my clutch pedal. If you pump it by hand real fast it will hold presser for a short time.
Hi there. The issue is the clutch master cylinder has an issue with the internal seals and is causing the brake fluid to slosh around in the chamber. I recommend replacing the clutch master cylinder. If you need further assistance...
Question
What does it mean if the Electronic Power Steering indicator comes on in the dash?
Your car is equipped with an electronic power steering system (EPS). This is very different from a conventional hydraulic system. If the Electronic Power Steering indicator in the dash comes on, there’s something wrong with the system. Here’s what you...
Question
Instruments, interior lights, radio, and power windows not working.
I would test all your fuses and make sure they are all good. There should be one for the instrument cluster and interior lights. Have a mechanic from YourMechanic do it if you are unsure how.
Question
Fuel pump not working properly.
Hi there. Without knowing the symptoms that are occurring with the car it will be hard to pinpoint what it is. Though it can be a fuel pump, those are not too common on this car. The majority of the...
Question
Vehicle idling roughly and stalling.
Hi there, you may need to have the memory of the engine computer read out by a scan tool. The Triton V8 engines have been known to have ignition coil breakdown over time and the misfire faults will be stored...
Question
How far can I drive when fuel light comes on?
Every vehicle is a little different as to how far you can go when the fuel light comes on. It would be only about 2 to 3 gallons in the reserve after the light comes on. I would suggest you...
Question
Lots of squealing from engine. I have been told idle pulley bad. Mechanic out of town. Should I drive car? Land Rover LR3
It would be recommended not to drive the vehicle until it is looked at by a certified mechanic. If the [idler pulley])(https://www.yourmechanic.com/services/idler-pulley-replacement) were to fail, the drive belt would be unable to spin the water pump and cause an overheating...
Question
Bad lighting coming from the low beams
Your Body Control Module (BCM) controls the headlights on your truck. According to GMC your headlights meet all safety standards; however they have a technical service bulletin (TSB) that may pertain to your situation. The TSB number PIT5374 dated February...
Question
Could the problem be my brakes or shocks?
The scraping sound you're hearing may be due to the parking brake contacting the drum in hat rotor without the parking brake being applied. You may need to replace the parking brake shoe and install a new spring clip retainer,...
Question
ABS/VDC/Slip light on.
Hello. If these lights were not on prior to replacing these parts then you need to start by checking the brake fluid. Low brake fluid or a bad brake fluid level sensor will cause this problem. If the fluid and...
Question
Temperature guage fluctuates between mid temp (normal running) and cold at higher speeds
This may cause other engine problems relating to the engine not warming up properly to run at normal operating temperature. There are many other systems that run based upon engine temperature and coolant temperature. Fuel injection and timing for example,...
Question
Doors keep unlocking. Using both manual and auto-lock.
I would have a technician inspect your electrical system. It sounds like you may have some electrical problems. There could be a shorted wire where the wires go into the doors or you may have a bad lock sensor on...
Question
What kind of fuel pump does a 2005 Chevy venture have so I can buy one?
Hi there. The OEM replacement fuel pump for a 2005 Chevrolet Venture is GM Part No.: 19180125. I think you'll find that if you have one of our professional mobile mechanics come to your location and complete the fuel pump...
Question
My ford Fairmond car brake works only by pressing hard on the brake pedal while driving to stop.
Hi there. First check the brake fluid and make sure that it's full and clean. If the brake fluid is black in color and is the original brake fluid in the vehicle, I recommend flushing the brake fluid to remove...
Question
Low oil light on even though I have oil in car.
Hello. The symbol that you are getting on the dash means that the computer has placed the engine in reduced power mode. This occurs as the engine computer tries to protect the engine from damage due to a condition it...