Popular questions

Claimed by Jay Safford

Used parts are sometimes acceptable; you just have to be careful and appreciate the risks. For it to be worthwhile be sure the discount is substantial. As a rough approximation, a used part would have to be no more than...

It sounds like you may have more than one issue with your car. The vibrating sounds like a wheel bearing and the clanking noise sounds like you might have a ball joint or a tie rod end that is worn...

Hi Jennifer. Thanks for writing in today. When it comes to extended warranties, it really is a hit or miss proposition. If you are going to be driving your vehicle frequently - especially in city stop and go driving, then...

The best way to diagnose this problem is to have your vehicle inspected by a professional, such as one from YourMechanic. However, I can make some educated guesses about your noise. There is a Technical Service Bulletin (TSB) for your...

Hi Jeff. Thanks for the question today. Warning lights are triggered when a sensor detects an error and creates an OBD-II trouble code then stores it in the ECU. The wrench light typically indicates that routine service or maintenance is...

If the vehicle is not restarting and there is no electrical power to the computer, then your automatic shutdown relay may be causing the problem. This relay is in the main engine relay box. If you are having a loss...

If the front drive shaft is spinning and not able to be engaged, then the chain in the transfer case could be broken. For the transmission to be in neutral in all the gears, but lock up in the park...

Check the battery charge level and charge the battery completely if necessary. The cranking voltage should not drop below 9.6 volts or the engine computer may not have enough power to come online and initiate fuel or spark. Listen for...

Hello. This is common because when the wheel is turned all of the way in one direction it puts the most pressure on the power steering pump. If the belt is good and tight then the pump is not bypassing...

Hello. If this happened right after replacing the battery terminal, then you may have a security system issue or a problem with the crank position sensor. Most of the time when you have a loss of voltage, the security system...

Hello, a common mistake that people make is thinking the battery may be good because the lights come on. A bad battery may allow power for the lights but not enough power to start the vehicle. The only way to...

Confirm that the engine immobilizer system (security system) is not activated thus preventing the car from starting. If the immobilizer system is on, you may see a security warning light. If the warning light is on, to temporarily override the...

Hello, having to replace bulbs is becoming more of a regular maintenance item on all cars. With the advancements in electronics and the metal used in contacts, we are able to get more voltage to bulbs than ever before. Going...

The rearview mirror is an important safety feature that provides you with visibility out your rear window. Before driving, you should always adjust your rearview mirror so that you have maximum visibility. To adjust the mirror, manually move it up,...

This is a question that will vary widely depending on who you ask and is often times subject to bias. With that being said, however there are some commonly known problems (as with any new model car or truck) that...

Hi. If by loose you mean a low pedal, you might have a hydraulic leak. The hydraulic system on your brakes is a sealed system. If you develop a leak, the pedal can go to the floor. Leaks can be...

The alternator may test good but may be cause of draw on battery. You will need to have the battery draw isolated by checking the circuits until the draw is found. This can only be done by isolating circuits. I...

Hello. A broken or worn engine mount will cause the engine to vibrate excessively. You may also hear a loud bang when the car shifts gears. A certified technician, like one from YourMechanic, should inspect the engine mount in order...

Hello, The first thing to check is all the fuses to make sure they are seated. There will be be more information needed to understand why the truck is not restarting. If it cranks and won't start, a scanner will...

Yes, you do have an old truck, but that doesn't mean it can't run well. If you noticed this problem about the time you replaced the catalyst, it could be that the replacement catalyst is not large enough to breathe...

Hello. There are a couple of reasons why your horn keeps going off. It is possible that one of the horn contacts is stuck or making contact in error. It is also possible that there is an issue with your...