Popular questions

The first thing you'd want to do is check the transmission and motor mounts. They all work together. Your vehicle is 14 years old and odds are that the mounts are worn. That's a common thing that happens with your...

I would suggest having the system pressure tested when the system is cold and do not forget to check the radiator pressure cap also for any leaks. Have the system pressure tested and it should not leak any pressure in...

Hello there, these are not uncommon problems for a vehicle to have when it sits for awhile. With the ABS light on, the most likely cause is low or poor condition brake fluid. Brake fluid absorbs moisture and can cause...

Hi there. The engine could be stumbling for the coil pack or distributor may not be functioning correctly. As the coil pack or distributor gets old, the parts tend to become weak and is not able to send an electrical...

In regards to the door that doesn't close always. The door latch mechanism can be lubricated with a spray lubricant. A dry graphie or white lithium grease are good lubricants to use. These will need to be sprayed on the...

Each of your key fobs is programmed specifically to work with your car. No other key fob will work with your vehicle. If you lose your key fob, or fear that it may be stolen, you want to unauthorized it,...

Hi Mike. Thanks for reaching out today. In most situations, a problem like this is caused by one of two things; either the brake master cylinder is malfunctioning (which is causing fluid to be applied to the brake caliper and...

This problem may be caused by a coolant temperature sensor, idle air control valve, throttle position sensor, or O2 sensor that may be failing. Use a digital volt ohm meter (DVOM) to check resistance on all of the sensors. If...

It sounds like you have a broken tie rod. There is an inner, and outer tie rod on both sides. Obviously, you can not drive the vehicle. All of the related parts need to be inspected for damage. This is...

Hi there, thanks for writing in. You can use the same bucket seat out of any GM truck whether it is a GMC or Chevrolet from the years of late 1989 all of the way up to 1998. This can...

A high idle upon cold start is generally normal for any vehicle as this is part of the cold start enrichment process as the engine warms up. As a general rule, car engines do not like cold weather and do...

The convertible top is controlled by the switch that signals the top module to open and close. When the button is pushed, the module turns on the light and performs the open or close operation steps. If any of the...

In your particular model vehicle, the wheel bearing comes pressed into the hub assembly. It may be possible to have the old wheel bearing pressed out and have a new bearing pressed into the hub assembly, however the machine work...

Hi, thanks for writing in. I'd be happy to offer my insight. It seems that the oil pump lost its prime when it drained for 8 hours with the oil filter off. I recommend removing the oil filter and filling...

The power steering in your car is electric. There is computer and an electric motor bolted to the steering column. If there is any malfunction, the computer will need to be scanned for codes to begin the diagnostics. There is...

VW / Audi has had lots of "issues" with sensors in the early 2000 model years. 2003 is one of them. The coolant temperature sensor is one of the most common. While it's not unusual for a coolant temperature sensor...

Hello - I suspect this may be a problem with the fan motor resistor pack. If the fan control is put in the "Max" or "High" speed position, does the fan continue to run? Does the fan only run for...

HI there - possibly. If it is one of the pre-catalytic converter oxygen sensors, yes, it is possible to damage the catalytic converters. From the problem codes, this would be a "Bank 1/2, Sensor 1" - the operative information that...

If the coolant level keeps dropping there is either an internal or external leak. Leaks are typically found by simple pressure testing of the cooling system. Engine coolant can leak externally through a hose, radiator, water pump, etc. or internally...

This could be caused by a loose lower cover plate. Trucks have a metal plate that protects the underside of the engine from debris. This plate is often removed for repairs and sometimes not all the bolts will be present...

Hello there, clutch replacement on your 2005 Dodge Neon is a large job. If the rattle started after the repair was performed then it's likely the repair caused the rattling. The throwout bearing slips over the release lever and should...

Hello - the first task is to see what problem codes are set, causing the Check Engine light to come on. Check oil level as well. Hopefully, the oil leak is not the root cause of the Check Engine situation....