Q: Replacemnet of crankshaft sensor

asked by on

Check engine light on. Runs rough wyen idling. Took to midas and they said maybe crankshift sensor

My car has 137000 miles.

A rough idle often times is related to an engine misfire. Engine misfires can be caused by many different problems and are generally caused by either a spark or fuel issue or in some cases, a combination of both. Spark related problems generally will result from things like ignition coils, crankshaft position sensor, spark plugs, spark plug wires or ignition modules not working properly. When the misfire results from a fuel related issue, this is commonly related to a lean fuel condition (lack of sufficient fuel supply to the motor). Fuel related misfires can be caused by many different things such as low fuel pressure, faulty or dirty fuel injectors, a faulty O2 sensor, a dirty or failing mass air flow sensor, a faulty or dirty idle air control valve or a vacuum or intake leak. When the fuel supplied to the combustion chamber is insufficient, this results in an ignition (spark) that is igniting a less than balanced load of fuel and air. This results in a misfire or an explosion in the cylinder that is much less powerful than the other cylinders. This creates a loss of power that resonates throughout the motor additionally causing other problems with ignition and fuel timing. Due to the number of different things that may cause an engine misfire, the quickest and easiest way to diagnose this type of problem is to hook the vehicle up to a scanning tool which will download any potential fault codes that may have registered in the vehicle’s computer as a result of the poor running condition. I would recommend having an expert from YourMechanic come to your location to diagnose your misfiring problem.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1,000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Replacemnet of crankshaft sensor

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Sound in the front right wheel well

A noise like the one you are describing probably originates at the rotor, caliper, or brake pads or the wheel bearings and CV axle. It is possible that the brake pads are not retracting from the rotor due to a...

Q: My VTEC engine variable timing solenoid keeps going bad every week to two weeks, yet that's the only code that pops up on Autozone

Hello, thank you for writing in. The fact the solenoid continuously fails may indicate that electrical side or mechanical side behind it is not working properly. You can do two things to start off diagnostics. First, considering the interaction with...

Q: ride height sensor

The ride height sensor(s) can be tested and such testing would be part of a diagnostic. There is, of course, a possibility of multiple issues such as leaks. Often, these systems will lock out if a leak is detected in...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...