Q: Have you ever done motor mounts on a toyota camry

You can play an iPod through the infotainment system by connecting it via an AUX cable or a USB cable. Both the AUX and the USB cables connect to the ports in the center console. While an AUX cable will...

Hello. It is very hard to say when a timing belt will break (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-timing-belt) as some fail before the required mileage and some go way beyond the recommended period. Either way you need to have this done as soon as...

Hi, thanks for writing in. This sounds like a bad fuel pump (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuel-pump) and or bad fuel filter (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuel-filter). The hard start may be a low fuel pressure cold causing the hard starting. Have the pressures tested and leak down...

This may be a sign of a failing throttle position sensor. This sensor is usually located on the butterfly spindle or shaft so that it can directly monitor the position of the throttle. It relays the position of the throttle...

Hi there. This is a very good question that I wish more people would ask. Your 2006 Pathfinder's engine control unit (ECU) does evolve and learn as it goes. Anytime you clean the throttle body (https://www.yourmechanic.com/article/how-to-clean-a-throttle-body-by-timothy-charlet) or complete major "routine"...

Hi there. There could be an issue with the battery or the electrical system for the vehicle to stall out randomly. Check the battery for any loose connections and to see if the battery is fully charged. If there is...

The knocking is suggestive of a mechanical failure of some sort. I would first measure cylinder compression to get a basic idea of the condition of the engine. If it doesn't test well (too low and/or too much variance) you...

Generally, replacing the bushings should keep the sway bar operating properly and doing what it is designed to do. When replacing the bushings, you may want to inspect the sway bar to make sure it is not bent or damaged...

The signal output of the vehicle speed sensor should be confirmed on a scan tool. There is a plastic gear on the end of the sensor (sold separate from the sensor) and that plastic gear is turned by the transmission....