Q: Error code P0139.

asked by on January 08, 2016

The Check Engine light is on. I get error code P0139.

Hello, you are going to have to take your car to the dealer. There is a Technical Service Bulletin (TSB) 18 033 06. This TSB will refer you to having the software updated in the engine PCM and transmission control unit.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Vent hose broke off of battery

The vents are so you will not get battery fumes built up inside the passenger compartment. Hydrogen gas may build up inside the car and can cause a fire hazard. I would not recommend driving it till you fix the...

Car stopped randomly and didn't drive afterwards

Hello, thanks for writing in. The computer will go into a failure mode and may not allow the electronic throttle to open if it detects a major computer or sensor fault. There can be many possible failures that will cause...

Got new lower ball joints. I can't even turn the steering wheel when backing up after the new joints were put on. It is a 2 wheel drive.

This is a common issue when new ball joints are installed and not properly aligned. I would suggest taking the truck to an alignment shop to be sure the alignment is on point. When not properly aligned, this can cause...

Related articles

P0553 OBD-II Trouble Code: Power Steering Pressure Sensor Circuit High Input
P0553 code means there is an issue with the power steering pressure sensor often caused by leaks or loose connections.
P2324 OBD-II Trouble Code: Ignition Coil I Primary Control Circuit Low
P2324 P2324 code definition Ignition Coil I Primary Control Circuit Low What the P2324 code means P2324 is an OBD-II generic code for the Ignition Coil I Primary Control Circuit Low to the Engine Control Module (ECM). This means the...
P0790 OBD-II Trouble Code: Normal/Performance Switch Malfunction
P0790 means a voltage or resistance problem with the transmission mode controller due to faulty wiring/connectors or faulty transmission mode switch.