Q: Q: Engine power reduced

asked by on

The Service Traction Control and Service Stabilitrak lights are on. The engine power is also reduced.

Multiple issues may cause your issue. The first step is to connect a diagnostic tool to your vehicle. It could be something simple or more advanced. A qualified mechanic, such as one from YourMechanic, can assist you with any repairs following proper diagnosis.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Q: Engine power reduced

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: The Adaptive stability control went out on my car I took it to a local mechanic he said he thinks the throttle is going bad he unh

Unfortunately, the cause of your concern cannot be determined without visual inspection and further testing. While it is possible that your throttle position sensor may be faulty, it is more than likely that it could be a wheel speed sensor...

Q: My 2010 Ford Escape vibrates a lot. There are no leaks at all. What could be the cause?

If the vibration happens when you're stopped at a red light, then it's more than likely caused by a vacuum leak, or fuel or ignition system component failure. Typically, the first three parts that would be inspected are the idle...

Q: Compressor it AC Belt?

Hi there. If the belt is failing or if the AC pulley bearing is failing, then this noise can occur. I usually remove the belt and check each of the pulleys to see if any of them are rough indicating...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.