Q: Car goes in all gears but will only move in reverse

asked by on February 08, 2017

Wont move in gear only reverse

My car has 198000 miles.
My car has an automatic transmission.

This is often a sign of low transmission fluid or a faulty transmission control solenoid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car’s computer activates a transmission solenoid, which directs transmission fluid into the valve body to engage the correct gear. When this is faulty or not working properly, this can cause a delay in gear shifting or in some cases cause the car to not shift at all. This type of problem is amplified any time the transmission is low on fluid creating a drop in hydraulic pressure.

This may also suggest a failing speed sensor. The transmission speed sensor is a magnetic sensor that provides this information, allowing the transmission to shift smoothly. The sensor counts the internal number of revolutions of the transmission and transmits that information to the transmission control unit, where the data is used to determine the rotational speed. As the rotation increases, the control unit directs the changing of gears. When this is not working properly, this may cause the transmission to shift erratically or in some cases not at all. I would recommend having an expert from YourMechanic come to your location to take the car for a test drive to more specifically determine the cause for this.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

Abs light, Trac light, service vehicle light on, brake pedal sinks to floor hard to stop vehicle

During the service of these components, the brake hose bolted to the caliper is not required to be removed. If it was removed and the brake system was not bled properly, air trapped in the system can cause your symptoms....

DTC code P0175

Claimed by Kevin Gainer

Very loud pop when turning sharp left leaking transmission or power steering fluid where steering column meet rack

Hi there. If everything else has already been installed from the donor vehicle then it sounds like the high pressure hose is all that you need to install. The hardest part of doing this is the routing. One thing you...

how munch does the rear differential hold?

Hello there, the fluid capacity of your 2002 Chevy Silverado 3500 rear differential is determined by a few different factors. The normal capacity is approximately 4 quarts. This changes based on if your truck is equipped with the limited slip...

The car idles and stalls in cold weather conditions only, or if i don't heat it up all the way in cold weather conditions.

Hello there. Many common faults will cause your 2012 Mazda 3 to idle poorly and stall in cold weather. The most common faults would be the coolant temperature sensor, stuck open thermostat, radiator, water pump, MAF sensor, or a wiring...

Trucks jerks erratically in 4th gear, about 50 mph.

Hello. This is a common problem when the throttle body sensor is faulty or dirty. There should be just 4 bolts holding this in place. I would recommend cleaning and checking this first before diving into transmission diagnosis. Also check...

My car engine is currently shot, and needs a replacement, is there any engines I can snap fit inside with little too know mods?

You can put just about any engine into your car but it will need to have modifications done to fit the engines. The 2000 through 2005 models have the same engine. I recommend putting in the same engine as what...

After driving few miles on a Mercedes ML500 all lights and signs goes on including the hard breaker and a beep sound starts.

I would want to check the Charging system first, because over-voltage or any stray alternating current can really wreck your control systems. You need to watch the dashboard and be sure to notice whether it is indeed all of the...

When i replace my radiator can i remove the condenser without replacing it and still drive my car with no problems? I

Hi Courtney. Thanks for contacting us today. I wouldn't recommend removing the condenser until you have the money to replace it. Everything is designed to fit correctly together. When you remove one component, other items will not work or fit...

Related articles

A Buyer’s Guide to the 2012 Mazda 6
The The Mazda 6 is a luxurious alternative to the everyday family sedan. It has decent fuel economy with an upscale look on both the inside and the outside. The vehicle also handles well on the highway and is comfortable...
The Top 5 Selling Cars in Arkansas in 2012
Arkansas, Arkansas, like many other states, has to deal with a wide range of weather, from the stifling to the icy. This means drivers need vehicles that can handle the heat while also helping them get through slippery conditions. In...
The Best Used Cars to Buy If You Don’t Have Kids
Buying Buying a used car is rarely a simple process, but if you don’t have kids, you have many more options than those who have to account for additional passengers. There are plenty of choices out there, depending on your...