Popular questions

An overall test of your air conditioning system would be helpful it sounds like the either the compressor isn't cycling refrigerant for some reason probably a leak in the system somewhere, a certified mechanic would be able to find the...

Hi. In a no start situation, there are always a few items that would need to be looked at. The first thing that is generally done is to read out any trouble codes in the engine computer. If codes are...

Before the purchase, you should definitely take a look at the car in person before moving forward - especially since it is a relatively older car. Just because it looks good in a picture does not mean everything works. There...

This could be caused by a faulty power steering cooling fan. The Mini's have an electrically controlled fan that will de-activate power assist if the fluid temperature exceeds a programmed standard to prevent damage to the power steering system. These...

You may have a clogged filter and should try having a transmission filter change and fluid replaced to see if it fixed the problem first before having the transmission further diagnosis done.

Hi there. Unfortunately, it's possible that your husband was correct about the cracked head gasket, but using a liquid "stop leak" product most likely made it worse. What likely occurred is whatever substance that was used to resolve the head...

Hello. If everything was done correctly then it should start right up. If it is not getting spark or fuel then I would check the crank signal. If the crank sensor is not sending a good signal then the computer...

Hi Andrea. Thanks for contacting us today. To be honest, if at all possible, none of these products should be used to fix a flat tire. Essentially, both products work by introducing a chemical formula to burn the inner lining...

The 440 has a flex plate with a ring gear. The starter needs to be removed and then see if the engine can be moved by hand. It may be a possibility that the starter and ring gear on the...

Hi there. Go to the brake pedal and look at the top of the leg of the pedal and you will see a switch that is mounted on the bracket that the pedal is hanging off of. That switch is...

The ground in your application is probably switched on and off through a controller assembly which also varies the fan speed. Obviously the motor is working when you apply full battery voltage but there is a controller in the circuit...

Hi there. It sounds like the transmission forward clutch plates are slipping. First check the fluid level and fluid condition by putting the dipstick fluid on a clean white towel and seeing if you see what looks like sand in...

Sent billing question to CS for cost to replace the oil pan gasket or timing cover gasket.

To install two new lower control arms costs about $600. An alignment is typically around $90. The engine mount including installation is probably around $165 total for this repair. The necessity of replacing the timing cover seal and/or...

Hello, thank you for writing in. The vehicle may be suffering from several different issues. In this type of situation you want to start with the least complicated option, and work your way up. Start by making sure your tires...

Hello. Depending on exactly where the short was it may not blow the fuse. Most of the time it will melt the resistor itself internally. It may also have a short in another location. I usually take a voltage meter...

Hi There, It may be difficult to tell what the light colored fluid could be as there are a number of fluids in the vehicle that serve various purposes. It may be likely that the light colored fluid may be...

Without additional detail as to what the issue is that you are experiencing, this may be tough to diagnose without physically inspecting the vehicle or taking it for a test drive. As you may know the speed sensors on your...

Yes, the fuses are a good start in a diagnosis, but if a fuse is blown, then a deeper problem may exist. The most common problem in your case is the brake light switch not making contact. I recommend that...

Hi TR. Thanks for contacting us today. If you could provide us with the exact code that came up, this would be much easier for us to help you locate the possible sources. Just because a code might indicate a...

From what you've described, it sounds like a belt broke. All of those systems are belt-driven. A visual inspection would easily confirm this. Don't try to start your engine, as overheating is the main risk for your engine now. I'd...

Hello. This is a common issue when the thermostat is failing. This may also be caused when the coolant fan relays are not working properly. If the thermostat is stuck closed, this may cause the coolant to not circulate properly...

Hello. There are few things which could be causing a problem with your 2nd and 4th gear. It could be that the shift linkage is out of adjustment, due to worn bushings, or it came out of adjustment when the...

The problem sounds like a misfire in one or more cylinders when under a load. The fuel system pressure would need to be checked to see if you have the correct amount of fuel pressure to run the car under...