Q: What does the Service Power Steering message mean?

The nozzle I believe your are mentioning is the anti-siphon and roll-over check valve. It does not require a perfect seal to the tank. The rubber filler hose slides over it, sealing in fuel vapors. I hope this helps. Put...

Hey there, thanks for writing in. You would need to have it metal clamped or welded on at an exhaust shop. Welding it will give you a better seal if the rest of the pipe is not damaged or rusted....

Hi there. This is a concern I have had a lot of experience with. Has the AC drain grommet been updated or removed? The original grommet was designed with a small slit style opening and was found to not be...

The mass air flow sensor (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement) is located just near the intake or throttle body and connected to the air filter. It should have a wire connector plugged into it that comes from the ECU.

Hi there - the best help going forward is to extract the problem codes turning on the Check Engine light. Most auto parts stores will read the problem codes for you for free. In a loss of power (https://www.yourmechanic.com/question/loss-of-power-while-driving) situation...

If you have tested the fuel pressure at the test valve on fuel rail and do not get pressure then the system will need to tested for a bad fuel pump.

I would suggest checking the Kelly Blue Book website with specifics related to your zip code as market prices of cars vary by zip code. This will give you a baseline for determining whether or not the car is within...

Hello. Most of the time this is caused by a failure in the transmission forward clutch pack. I usually check the transmission fluid and drop the pan to check for debris. If there is then the transmission needs to be...

Hi there. This type of ticking noise when the AC is active is common with bearings from the pulley system attached to the compressor starting to fail. It is possible to replace the AC compressor pulley and repair damage to...