Q: how to bypass heater core in 2006 dodge caravan

asked by on April 28, 2017

want to bypass heater core in 2006 dodge caravan

In order to bypass a heater core you will need to disconnect both hose connections at the heater core on the engine firewall and then connect the two hose ends together using a bypass pipe and two hose clamps then top off coolant.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

No heat in my 1995 Jeep Cherokee

Hello - to resolve your "no heat" issue, first check that the engine is running at design temperature (center of the gauge), or 190-205 degrees Farenheit. If engine is up to temp, grab the heater hoses (carefully) inside the passenger...

Engine overheats, heater blows out cold air, coolant boils in radiator

Sounds like multiple problems here. I would first correct the "no heater" scenario. This is likely the heater control valve not allowing what is clearly hot water into the heater core. The reason for correcting this first is that it...

My heater only blows cold air

Check the operation of the heater control valve, which is often located on the engine compartment firewall. If that valve doesn't move to the commanded position, or move fully, you will have a no heat condition. If the valve is...

Heater blows out cold air 2006 Nissan Xterra

Hello - the lack of heater function could have 5 causes: the engine is not getting up to correct temperature (center of the gauge) due to a malfunctioning thermostat, the heater control valve is not letting hot coolant into the...

How much to flush out system cause car has no heat

The heater core being plugged is not the most common cause for this vehicle to not give heat out of the vents. If you move controls to heat and do not notice a temperature change when turned hotter the most...

Heater not working 2005 Acura TL

Hello - you may have a bad water pump and clogged radiator. When engine overheating occurs at low engine speeds, it indicates the engine is unable to transfer heat to the radiator and cool the engine. It would also result...

There is no heat blowing out of the inside vents.

No heat from the vents can be caused by a few different things. A few things I would check are the thermostat and heater control valve, as these are two components that control flow to the heater. If the thermostat...

Heater only works on high. Heat is not hot.

If your heater only blows when the setting is on high, this may suggest that you have a faulty blower motor resistor. The highest speed setting may still work because in most cars in the highest fan speed settings the...

Does my 2012 Ford Escape have a heater control valve?

Hi there, thank you for asking about your 2012 Ford Escape. To answer your question, no, your vehicle does not have a heater control valve. Hot coolant will continually move through the heater core as long as the engine is...

Related articles

How to Replace a Heater Control Valve
Car heater control valves regulate the flow of coolant into the cabin. Heating and cooling issues result when the heater control valve fails.
How to Remove and Replace a Heater Control Valve
The heater valve is integral to a vehicle’s cooling system. Replacing one requires a new valve, some basic tools, and fresh coolant.
OBD-II Trouble Code P0371: Timing Reference High Resolution - Signal A - Too Many Pulses
P0371 means there is an issue related to an ignition system error or misfire, likely due to a defective camshaft or crankshaft position sensor.