Popular questions

This could be a variety of things ranging from a fuel delivery problem to a no spark problem. The good thing is you know you are getting power to the starter if it cranks. Outside of this you will need...

Hi Tyler. Thanks for sending the question tonight. If you've just replaced a battery (like in the last 24 hours) then I would suggest checking the battery cables for corrosion or check your ignition relay. If the battery was replaced...

Hi There, This may be a sign of a faulty MAP sensor as the vehicle responds adversely to a load put on the motor (i.e. putting it in gear, turning on AC or engaging the brakes). The Manifold Absolute Pressure...

Hi there. There could be a few different issues that could be contributing to your current condition. There could be a vacuum leak causing the engine to rev up when there is no load applied to the engine. The Idle...

Brake system flush will be the same as bleeding and will be a minimum of one hours labor.

When the climate control unit on your vehicle stops functioning and is stuck on one setting it is typically caused by a hardware failure in the unit. This module would need to be replaced in order to fix it. Unfortunately...

Hi there. From the description you have given, your vehicle's front end wobble should be diagnosed and repaired before, something breaks. Your safety is priority one. Assuming, whether it is 2wd or 4wd, it could be worn ball joints. It...

Hi! That is a Jeep issue I have not seen with my own eyes. It makes me think that there may be a misalignment between the pedal and the pushrod. Possibly a worn bushing on the pedal allowing it to...

Hello there. There are many potential causes for reduced power output. The most likely would be the fuel pump, low fuel pressure, battery, alternator, or fuel filter. A bad throttle sensor can cause this issue but the throttle body itself...

Hi. These cars have a know problem with the push rods and or the lifters going bad causing knocking and tapping noises. There is also the possibility that the ball bearings in the alternator or A/C compressor are going bad...

Hi. A clicking noise while turning in a front wheel drive car is usually caused by damaged or worn CV joints. CV joints are mounted on each end of a front axle and they transfer power to the wheels from...

An engine not starting may be related to many different possibilities, some of which may be related to a lack of spark and some of which may be related to a fuel delivery problem or a combination of both. For...

There is no history of premature failure of Toyota OEM coils in this application. Aftermarket coils might be a different story, though. A typical cause of coil failure is faulty spark plugs that create a high resistance (or faulty wires...

Hi there. This sounds like an issue with your vehicle's safety device malfunctioning. I strongly suggest having a certified technician, such as one from YourMechanic, correctly diagnose the door locking issue more precisely.

Hi there. The engine cooling fan is controlled via a relay by the engine computer. Fuse 57 needs to be checked along with the cooling fan relay as soon as the fan should be initiated. Voltage needs to be checked...

Hi there. This is a perfect example where having one of our professional mobile mechanics come to your location to complete a steering wheel will not turn inspection is the best option. One of our mechanics can come to your...

The vehicle is misfiring (based on the codes) and a common cause of the misfiring is a faulty engine management sensor. The solution to a problem such as this relies on a "diagnostic decision tree" that is set forth in...

Hi Mike. Thanks for contacting us today. Any high temperature sealant will work the same on head gaskets and valve covers. As long as you've already completed the head gasket replacement and the cylinder head or engine block is not...

Your car uses the KE injection system which is unique in that the electrical system can fail, and the injection system will still operate and keep the car running. Only problem is, you don't have any fine fuel trim like...

The code is for the camshaft position sensor no rpm signal. The sensor is mounted in the cylinder head and monitors the camshaft turning. The sensor and its wiring should be tested first then if needed the sensor can then...

If gasoline was left in the fuel tank for 2 years, the tank would have to be thoroughly drained. The fuel filter should be replaced and it is preferred to remove the fuel injectors from the fuel rail and send...

Hello there. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. Once running, the engine requires a constant flow of fuel and good spark to keep that fuel igniting. If fuel...

Hi there. Unfortunately, we are unable to assist with aftermarket upgrades and tech questions as you've listed above. We only offer OEM service, tips and maintenance suggestions for cars, trucks and SUV's sold in the US. Thanks for contacting us...

Locking and unlocking your doors is as simple as using the remote, the electronic key or the mechanical key. However, there are a few things that you should know so you’re not taken by surprise when they happen: You...