Q: My car alarm no longer flashes when activated

In order to fill your gas tank, you’ll need to open the fuel door. However, your fuel door is secured in order to prevent possible siphoning attempts. To open the fuel door, you’ll need to use the switch. Here’s how:...

Hello. Your brakes can lock up for many reasons. If the wrong brakes were used or if they are contaminated with oil or grease than this will occur. If neither of these are present then there may be a problem...

The mass air flow sensor measures the speed of the air going into the engine. The P0101 code (https://www.yourmechanic.com/article/-p0101-obd-ii-trouble-code-mass-airflow-maf-circuit-operating-range-or-performance-problem-by-john-nelson) could be an electrical issue. The PO449 code (https://www.yourmechanic.com/article/p0449-obd-ii-trouble-code-evaporative-emission-control-system-vent-valve-solenoid-circuit-malfunction-by-spencer-clayton) is related to fuel tank emissions. Codes give you the area of...

Hesitation is a common sign of a failing mass air flow sensor. This is a unit that monitors the air flow into the engine as it is mixed with fuel to create the optimum air/fuel ratio. When this is not...

Hello. I suspect the heater control valve is the culprit here. Most likely only opening partially. By only being partially open, it allows more hot water to circulate when the engine load and RPM are higher, as when you accelerate,...

Hello. You will leave the clips in and the lines will snap in place (https://www.yourmechanic.com/article/how-to-replace-oil-cooler-lines-on-most-cars-by-ty-thompson). To help the lines slide in easier you can use fresh transmission fluid to lube the end of the line so it will get by...

The most common cause of hard start after fill up (https://www.yourmechanic.com/services/car-is-hard-to-start-inspection) is going to be the excessive gas fumes during refueling the vehicle will flood the engine causing the hard or no start. The excessive fumes will normally be stored...

The issue could be the steering column lock mechanism or the key cylinder, or both. To repair those components, typically there will be partial disassembly of the steering column. That is a sensitive area as the air bag is installed...

Hi there. It's more than likely that your serpentine belt or one of the pulley's is loose or worn out. Usually this will cause the type of sound you are hearing. However, it's also possible that a wheel bearing is...