Q: I need to replace my turbocharger boost sensor.

asked by on October 06, 2017

My car has both a MAP sensor and turbo boost sensor. Both look the same. Can I tell them apart by location in the vehicle?

My car has 105000 miles.
My car has an automatic transmission.

You have two charge pressure sensors and are labeled sensor 1 located near left rear of motor and has a violet, brown and blue wires going to it. The second sensor is also on left rear of motor and has violet/wht, pink/black and brown wires to it. The code you get will determine what one to replace.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Car failed emissions test

Hi, to fix this problem you will need to replace the intake manifold gaskets. That will take care of the Barometric Pressure Sensor. I would inspect the exhaust gas recirculation (EGR) valve, since it may have been left open causing...

I can't get my truck out of four wheel drive

Hello. Most of the time this occurs when the actuator in the transfer case fails. If the actuator was not when you went through the puddle then that could cause it to fail from the sudden change of temperature. This...

Engine turns over but won't start

The ignition coil, ignition control module, or distributor rotor can all fail without warning, leading to a no start. The reason I am leaning towards an ignition system issue is that the vehicle was running before you went to the...

Engine overheating and heat not working. Might need gasket.

When the engine is overheating and the heater does not blow hot the most likely cause is a low coolant level. If all those parts were replaced on your vehicle perhaps important parts were skipped over during the inspection. You...

My Toyota Will not move in reverse when the engine is hot

If your car will reverse in when cold but not when hot, it's likely that you're looking at a mechanical failure in the transmission. automatic transmissions use hydraulic pressure to operate the various clutches and bands that shift the gears....

Squealing noise

Hello. It sounds like your drive belt may need adjusting. Drive belts that are too loose can squeal, especially when the engine is cold. I suggest you have a trained professional, such as one from YourMechanic, adjust your belt to...

Piston cylinder

A tutorial on cylinder honing (and grit size recommendations) is at this link. For ring gap recommendations, please see this link or the Factory Service Manual for your vehicle. If you have not honed cylinders in an engine block before,...

BAS/ESP light coming on

Your vehicle may be having an issue with the connections to the brake sensor. The connections may have corrosion which will make the system go into failure mode, intermittently causing the throttle to not respond. I recommend having your brake...

Car stalls at a low speed

Hello. You can try and clean the IAC valve, but if it is bad, it will need replacement. Cleaning the IAC valve would only be a temporary fix. The IAC valve is usually attached to the throttle body, and can...

Related articles

What Sensors Do All Cars Have? And What Optional Ones Are There?
Modern cars have an increasing amount of sensors. Most cars have an oxygen sensor and a throttle position sensor, but parking sensors are optional.
How to Get Volvo Dealership Certified
Volvo dealerships offer automotive technician jobs to mechanics who are certified through the Volvo Service Automotive Factory Education program.
The Most Common Error Codes for Transmission Problems
If your Check Engine Light has come on, there are a number of conditions that could be causing it. Many are related...