Showing articles & questions for topic
B2500

You're not imagining it. The ignition switch is made up of two parts, the lock assembly which handles the job of locking the steering column, and the switch element which does the electrical work. The switch element is made of...

Backfiring (https://www.yourmechanic.com/article/what-causes-a-car-to-backfire) is often caused by a too lean or too rich air-to-fuel ratio although a few other causes are discussed below. A backfire in the intake manifold is caused by a ratio that is too lean (not enough fuel)....

If you are referring to the engine coolant temperature gauge on the instrument panel, unless the gauge is misreporting the temperature (https://www.yourmechanic.com/services/temperature-gauge-is-maxed-out-inspection), a likely cause of too low of an engine temperature is a cooling system thermostat (https://www.yourmechanic.com/services/thermostat-replacement) that is...

As far as the brake issue, yes, there needs to be a check to see if there is brake fluid entering into the proportional valve. If there is fluid supply to the valve but not out then the valve will...

This noise, if it increases with road speed, is quite likely a worn front wheel bearing (https://www.yourmechanic.com/services/wheel-bearings-replacement). It may be from one side or both sides. If you turn left while moving, and the noise increases (let's say on a...

The only way this can logically happen is if an oil line from the engine is being connected to a failed "oil cooler" inside of the radiator. The engine oil is under far greater pressure than the coolant in the...

Hi there. As the service manual reads, the resistance between pin 2 on the range switch and pin 6 black PCM connector must be checked for less than 5 ohms of resistance. Any more than 5 ohms of resistance and...

You would need to have it programmed to your VIN. Have the computer scanned to see if you have a good crank shaft signal first, before replacing the ECM. You may not need the ECM replaced; you may have a...

Hello. If the coolant level is where it should be then you should get some flow from the heater tube. It will not be a lot of flow, but there should be some. If there is none then you may...

The turn signal lighting is all supplied power from the same turn signal relay. Since LED lighting consumes less power it should be heavy duty enough to use but you may want to check with LED lighting manufacturer through their...

To read the flash codes, make sure you have a clean and stable chassis ground or the codes will not flash. If there is a secure ground and no flash codes, then it is quite possible that this is an...

According to Gates, a leading manufacturer of timing belts, your 2.3 liter engine is a non-interference engine. This means that a timing belt (https://www.yourmechanic.com/services/timing-belt-replacement) failure as you describe should not cause the valves to strike the pistons causing serious damage....

Hey there. It's possible that the teeth on the flywheel (manual transmission) or flexplate (automatic transmission) are worn or banged up sufficiently that the starter drive on the starter won't engage properly. Moving the crankshaft as you mention may realign...

Hi there. This can be caused by a number of things. If it occurred right after the work was done then you may want to have it double checked. They may have used poor quality wires or the wrong spark...