Mini Cooper Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(727)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(727)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Mini Cooper Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2013 Mini CooperL4-1.6L TurboService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2003 Mini CooperL4-1.6L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2014 Mini CooperL4-1.6L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2006 Mini CooperL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2005 Mini CooperL4-1.6L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
2020 Mini CooperL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2022 Mini CooperL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2005 Mini CooperL4-1.6LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$117.94 - $131.39
Show example Mini Cooper Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mini mechanics

Real customer reviews from Mini owners like you.

Excellent Rating

(727)

Rating Summary
692
17
5
1
12
692
17
5
1
12

Arturo

27 years of experience
303 reviews
Arturo
27 years of experience
Mini Cooper L4-1.6L Turbo - Car starts and then dies Inspection - San Diego, California
Really great mechanic. He knew right away what was wrong with the car based on what I told him before running the diagnostic and he was also explaining carefully what each code meant. Super nice to work with and converse with while working on the car.

Ben

41 years of experience
1410 reviews
Ben
41 years of experience
Mini Cooper L4-1.6L - Car starts and then dies - Houston, Texas
Ben was really nice and fixed my Mini Cooper up in less than 30 minutes!

Jeremy

20 years of experience
592 reviews
Jeremy
20 years of experience
Mini Cooper L4-1.6L Turbo - Car starts and then dies - West Palm Beach, Florida
Very good

Peter

43 years of experience
1321 reviews
Peter
43 years of experience
Mini Cooper L4-1.6L Turbo - Battery - Phoenix, Arizona
Fast, friendly, convenient

Excellent Rating

(727)

Rating Summary
692
17
5
1
12
692
17
5
1
12
Number of Mini Cooper services completed
7997+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mini MECHANICS
400+
experts on our platform

Recent articles & questions

How to Buy Good Quality Doors
It It happens to the best of us – accidents, shopping carts, the dings and weathering of time take their toll on your car door and soon you may find yourself shopping for a new one. The kind of car...
How to Start a Diesel Truck
Starting Starting a diesel engine (https://www.yourmechanic.com/article/what-is-the-difference-between-a-diesel-and-a-gasoline-engine) is a lot different than starting a gas-powered engine. Whereas a gas engine starts when the fuel is ignited by the spark plug, diesel engines rely on the heat created by compression in the...
How to Replace an Exhaust Gas Recirculation (EGR) Cooler
Exhaust gas recirculation (EGR) coolers lower the temperature of the exhaust gas before it enters the car engine. EGR coolers are mainly for diesel.

I have problem ( Engine power Reduced ), Code 1682 ignition 1 switch circuit 2

The P1682 code means that there is a difference in voltage between the ignition switch circuit 1 and circuit 2. There are a few things that can cause this - including a fault with the ignition switch (https://www.yourmechanic.com/services/ignition-switch-replacement) itself or...

Service Engine Soon Light and P1441 Code, even after replacing purge solenoid

Although some codes require a certain number of drive cycles without problems to reset the Check Engine Light, it sounds like there is still fuel vapor flow from the EVAP system into the engine when there should not be. It's...

Wheel lights on my truck. Are they legal or illegal to have?

The law states that lights are to be stationary on a vehicle unless they are for a purpose vehicle with a strobe light, like a tow truck. Also the law states that the lights cannot create a distraction to the...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com