BMW 128i Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(91)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(91)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a BMW 128i Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2008 BMW 128iL6-3.0LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2010 BMW 128iL6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2012 BMW 128iL6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2009 BMW 128iL6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2013 BMW 128iL6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
2011 BMW 128iL6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
Show example BMW 128i Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert BMW mechanics

Real customer reviews from BMW owners like you.

Excellent Rating

(91)

Rating Summary
85
4
1
0
1
85
4
1
0
1

Jermaine

24 years of experience
270 reviews
Jermaine
24 years of experience
BMW 128i L6-3.0L - Brake Pads Replacement (Rear) - Burtonsville, Maryland
Very knowledgeable and personable. Did a great job and finished ahead of schedule.

MICHAEL

33 years of experience
184 reviews
MICHAEL
33 years of experience
BMW 128i L6-3.0L - Coolant is leaking - Philadelphia, Pennsylvania
Knowledgeable, friendly and professional

Mark

11 years of experience
349 reviews
Mark
11 years of experience
BMW 128i L6-3.0L - Window Motor / Regulator Assembly Replacement (Driver Side Front) - Cupertino, California
Mark is great and very helpful!

Charles

34 years of experience
342 reviews
Charles
34 years of experience
BMW 128i L6-3.0L - Oil Change - Austin, Texas
Great job

Excellent Rating

(91)

Rating Summary
85
4
1
0
1
85
4
1
0
1
Number of BMW 128i services completed
1001+
services done by our mechanics
TOTAL NUMBER OF EXPERT BMW MECHANICS
1100+
experts on our platform

Recent articles & questions

A Buyer’s Guide to the 2012 Dodge Journey
The The 2012 Dodge Journey is easy to drive, and it’s not so large that you will have a difficult time parking it. It’s an attractive vehicle that has the power you need whether you are hauling a full carpool,...
P0190 OBD-II Trouble Code: Fuel Rail Pressure Sensor Circuit Malfunction
P0190 trouble code definition Fuel rail pressure sensor circuit malfunction What the P0190 code means The power control module (PCM) has detected...
Insurance Requirements for Car Registration in Washington
All All drivers in the state of Washington are required to carry liability insurance, or “financial responsibility,” on their vehicles in order to legally operate a vehicle and maintain vehicle registration. This applies to all vehicles except: Motorcycles Motor-driven bicycles...

Cost for parts replacement and oil change.

For this type of work the cost will vary tremendously depending on where you have it fixed. Parts prices and hourly rates will vary depending on the shop. The one thing that does not change is the time it takes...

Car did not engage going forward, nor in reverse

Hi we will be happy to help. The issue you are experiencing is likely due to a form of preventive maintenance that your vehicle needs. The maintenance that I'm referring to is the clutch actuator adjustment. Overtime, the clutch will...

It's a 2007 Chrysler [300](/topics-300/) originally it threw p30

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com