Audi A5 Front Crankshaft Seal Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(9)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(9)

Front Crankshaft Seal Replacement Service

How much does a Front Crankshaft Seal Replacement cost?

On average, the cost for a Audi A5 Front Crankshaft Seal Replacement is $470 with $14 for parts and $456 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2013 Audi A5L4-2.0L TurboService typeFront Crankshaft Seal ReplacementEstimate$622.07Shop/Dealer Price$723.62 - $839.22
2012 Audi A5L4-2.0L TurboService typeFront Crankshaft Seal ReplacementEstimate$508.79Shop/Dealer Price$606.16 - $708.91
2010 Audi A5L4-2.0L TurboService typeFront Crankshaft Seal ReplacementEstimate$508.79Shop/Dealer Price$606.15 - $708.89
2014 Audi A5L4-2.0L TurboService typeFront Crankshaft Seal ReplacementEstimate$484.87Shop/Dealer Price$576.06 - $660.72
2011 Audi A5L4-2.0L TurboService typeFront Crankshaft Seal ReplacementEstimate$508.79Shop/Dealer Price$606.28 - $709.13
Show example Audi A5 Front Crankshaft Seal Replacement prices

What is the Front Crankshaft Seal all about?

A number of mechanisms must work together to make your vehicle move forward. One of the most important is the crankshaft, which converts rotary into linear motion; i.e., it transforms the force created by the engine's pistons moving up and down into a force that moves in a circular motion that causes a car’s wheel to turn. Enclosed in what’s called a crankcase—the largest cavity in the engine block, just below the cylinders—the crankshaft must be completely lubricated, essentially submerged in oil, to spin nearly friction-free and do its job properly.

Consequently, there are seals located at either end of the crankshaft that allow it to spin freely and keep engine oil from escaping the engine block, as well as prevent contaminants and other debris from entering and causing damage to the mechanism. Since there are two ends of the crankshaft, there are two types of seals: the front crankshaft seal and the rear crankshaft seal, also known as the front main and rear main seals.

Keep in mind:

  • Loss of oil will eventually cause serious internal engine damage.
  • Inspect the sealing surface of the crankshaft or the crankshaft pulley (depending on the engine design) for damage when replacing the crankshaft seal.
  • Oil degrades rubber components.

How it's done:

  • The vehicle is raised and supported on jack stands
  • The crankshaft damper and timing belt is removed
  • The crankshaft seal is removed and a new one installed
  • The timing belt and cover along with crankshaft damper is reinstalled
  • The engine accessory belts are installed and the vehicle is lowered off of the jack stands

Our recommendation:

One of the most important parts of your car, crankshaft seals are typically made from a durable material, such as a synthetic rubber or silicone, designed to handle the extreme pressure and temperatures as well as the caustic chemicals in your engine oil. Because they are exposed to such abuse, main seals are subject to a lot of wear and tear. And whether you are talking a front or rear main seal, replacement is the only cure when one malfunctions.

The good news is that the seals are relatively inexpensive components. The bad news is that neither is easy to replace.

Front seal: The front seal is located behind the main pulley that drives all the belts, which is, of course, always spinning. The main pulley throws any leaking oil out in a big circle. It can get thrown up on the alternator, steering pump, belts, in short anything attached to the front of the engine and cause a real mess and eventually some serious damage. Consequently, it has to be removed along with many of the components attached to the front of the block to replace the front main seal.

Rear seal: The rear crankshaft seal is placed along with the transmission; therefore, the process of replacing it requires the removal of transmission, as well as the clutch and flywheel assembly. This is a very involved job.

What common symptoms indicate you may need to replace the Front Crankshaft Seal?

  • Oil leaking from the front crank pulley.
  • Oil dripping from the bottom of the clutch housing, where the block and transmission meet.
  • Clutch slip caused by oil spraying on the clutch.

How important is this service?

Letting either crankshaft seal continue to leak can be detrimental to your vehicle’s continued operation. Besides the maladies caused by driving around with little to no oil flowing in the engine, the faulty seal will be spread oil through the engine bay and undercarriage of your car as you drive, a mess that is difficult to clean up and can be a fire hazard. Replacing is better addressed sooner than later.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Audi mechanics

Real customer reviews from Audi owners like you.

Excellent Rating

(9)

Rating Summary
8
0
1
0
0
8
0
1
0
0

Brian

24 years of experience
200 reviews
Brian
24 years of experience
Audi A5 L4-2.0L Turbo - Smoke from engine or exhaust Inspection - Hagerstown, Maryland
Very Professional, courteous and knowledgeable. Always exceeds my expectations.

Victor

35 years of experience
226 reviews
Victor
35 years of experience
Audi A5 L4-2.0L Turbo - Coolant is leaking - Albuquerque, New Mexico
Very professional and thorough. Did not try and upsell things not needed.

James

31 years of experience
684 reviews
James
31 years of experience
Audi A5 L4-2.0L Turbo - Brakes, Steering and Suspension Inspection - Fullerton, California
Excellent experience. On time. Professional. Courteous. Honest. I requested brake pad repair (only because dealer said so, and I already procrastinated a year), but James took a look and said it's still good! No need for replacement, but James still did a thorough inspection on the car. Appreciate the time he took to explain things, the audio and visual report as well.

James

31 years of experience
684 reviews
James
31 years of experience
Audi A5 L4-2.0L Turbo - 75,000 Miles Maintenance Service - Fullerton, California
My second time with James. His service continues to be excellent. Would 10/10 recommend.

Excellent Rating

(9)

Rating Summary
8
0
1
0
0
8
0
1
0
0
Number of Audi A5 services completed
99+
services done by our mechanics
TOTAL NUMBER OF EXPERT Audi MECHANICS
700+
experts on our platform

Recent articles & questions

Top 10 Scenic Drives in New Mexico
It is difficult to characterize New Mexico with its array of cultural influences and diverse terrains. From sweeping desert lands to verdant forests to regions that look more like the surface of a distant planet than a part of Earth,...
The Guide to Right-of-Way Laws in Texas
At At times, one driver is going to have to yield to another, or to a pedestrian. This is both common sense, common courtesy, and law in the state of Texas. Right-of-way laws are in place for the protection of...
P2562 OBD-II Trouble Code: Turbocharger Boost Control Position Sensor Circuit
P2562 Code Definition The P2562 code is a generic powertrain code related to vehicle speed control and the idle control system. It...

My horn won't work

The horn being inoperative could be from either the steering wheel clock spring, or the horn assembly. Both have been known to cause the problem you described. The Check Engine Light could be on for a sensor problem, or a...

Battery not charging and car unable to start

The problem you are having sounds like a starter assembly failing, but this usually causes a click from the relay (https://www.yourmechanic.com/services/starter-relay-replacement) or the starter assembly (https://www.yourmechanic.com/services/starter-replacement) which is fastened to the engine. I recommend having a local expert, like one...

I have a 2006 dodge magnum 6.1l hemi engine,car starts right up and revs fine when put in drive or reverse it turns off!

This is caused by the transmission internal or solenoid issue. The transmission is trying to go into reverse and forward gear at the same time. Have the transmission tested for solenoid or other internal issues with transmissions.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com