Volvo 960 Oil level is low Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(19)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(19)

Oil level is low Inspection Service

How much does a Oil level is low Inspection cost?

On average, the cost for a Volvo 960 Oil level is low Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1997 Volvo 960L6-2.9LService typeOil level is low InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1994 Volvo 960L6-2.9LService typeOil level is low InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1995 Volvo 960L6-2.9LService typeOil level is low InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1996 Volvo 960L6-2.9LService typeOil level is low InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1993 Volvo 960L6-2.9LService typeOil level is low InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1992 Volvo 960L6-2.9LService typeOil level is low InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Volvo 960 Oil level is low Inspection prices

A vehicle needs oil to run and without it, or too little of it, severe damage can happen to the engine. Engine oil lubricates all of the major moving parts of the engine, which cuts down on wear and tear and dissipates the heat the engine generates. Not having enough oil in a vehicle can be deadly to the car’s engine.

Engine oil operates in a closed loop system so if the engine is losing oil at a significant rate, there is a problem somewhere, most likely a leak.

How this system works:

Engine oil is stored in the oil pan, which holds 4 to 6 quarts of oil depending on the vehicle. When the vehicle engine is started, the oil pump sucks oil from the oil pan through a part called the pickup tube. The oil is then pumped into the oil filter, which removes the dirt and debris that has accumulated in the oil. The engine oil then circulates throughout the engine via spurt holes before heading back to the oil pan where the process starts all over again.

Common reasons for this to happen:

  • Oil Light Comes On: The Low Oil Engine Warning light will illuminate when the oil level gets lower than it should in the oil pan. This warning light varies on vehicles but in most it looks like an oilcan with a droplet coming out of the spout. If this light illuminates for more than a couple of seconds at start-up the car should be inspected immediately as the oil level is too low in the car. This can lead to damage to critical engine components and expensive repairs.

  • Oil Leak: An oil leak can occur in just about any of the oil system components. Common problems are leaking or failing oil pan gaskets. As gaskets and seals age they tend to shrink and fail letting oil escape the system. A leaking gasket can quickly turn into an expensive repair if not addressed, as critical components will not have the lubrication they need to operate safely.

  • Worn Piston Rings: Piston rings help control the oil pressure in the vehicle. If they are worn or damaged the oil levels in the car will drop. Look for white or gray exhaust smoke, slow acceleration and excessive oil consumption. This problem can quickly damage critical and expensive engine components such as the pistons themselves and should be repaired quickly.

  • Faulty Worn Valve Guides: Valve guides are a cylindrical piece of metal that is pressed or cast into the cylinder head. They help to conduct heat away from the combustion process and into the cylinder head where it may be taken up by the cooling system. If valve guide seals are worn, cracked or broken the engine will suck oil down the guides and dump it into the cylinder, which will pull oil from the lubrication system. Oil levels will drop. This problem should be addressed as soon as possible.

  • Incorrect Oil Type: Engines can be filled with low viscosity synthetic oil, which reduces friction and increase fuel efficiency. A lower viscosity oil is thinner and can leak past rings and the seals on valve guides resulting in a loss of oil. Synthetic oil should not be used for the engine break-in period.

  • Assembly Mistakes: Piston rings that are not seated or sealed properly can cause oil to leak out of the engine. This problem can result in significant oil loss. The engine must be rebuilt to correct this problem.

What to expect:

Oil will become black and a bit gritty over time, this is normal and does not indicate that the oil needs to be changed. Most modern oils, especially the synthetics can last between 7,000 and 10,000 miles before they need to be changed.

How it's done:

A mechanic will inspect your car for oil leaks, the oil type and check to see if the oil level warning light is operating as it should. The mechanic will also inspect some related engine components. This will include valve guides, piston rings and more.

How important is this service?

Loss of engine oil is almost always a sign of a more serious problem. Engine oil is literally the lifeblood of the car and if the levels get too low it can damage critical components of the engine. Oil loss or high oil consumption should be investigated as soon as possible.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Volvo mechanics

Real customer reviews from Volvo owners like you.

Excellent Rating

(19)

Rating Summary
19
0
0
0
0
19
0
0
0
0

Lucas

21 years of experience
893 reviews
Lucas
21 years of experience
Volvo 960 L6-2.9L - Brake Pads Replacement (Front) - North Hollywood, California
Only mechanic I want to work with.

H

26 years of experience
828 reviews
H
26 years of experience
Volvo 960 L6-2.9L - Radiator Flush - Saratoga, California
Probably the most helpful mechanic in the bay area

Richard

21 years of experience
461 reviews
Richard
21 years of experience
Volvo 960 L6-2.9L - Car is not starting - Jonesboro, Georgia
Richard was very professional and knowledgeable. Willing to recommend him to anyone!!!!

Alex

16 years of experience
435 reviews
Alex
16 years of experience
Volvo 960 L6-2.9L - Check Engine Light is on - Garland, Texas
Professional expert mechanic

Excellent Rating

(19)

Rating Summary
19
0
0
0
0
19
0
0
0
0
Number of Volvo 960 services completed
209+
services done by our mechanics
TOTAL NUMBER OF EXPERT Volvo MECHANICS
600+
experts on our platform

Recent articles & questions

The Guide to Right-of-Way Laws in South Dakota
If If vehicles or pedestrians are approaching one another, in the absence of signals or signs that can regulate the flow of traffic, right-of-way laws apply. Since most accidents occur as a result of failure to yield the right of...
Disabled Driver Laws and Permits in Rhode Island
In In Rhode Island, there are laws in place that allow special privileges to handicapped drivers. If you are handicapped, then you will be entitled to special placards or license plates that identify you as such, and you will be...
P0390 OBD-II Trouble Code: Camshaft Position Sensor “B” Circuit (Bank 2)
Trouble code P0390 means the PCM does not detect the camshaft position sensor B signal and is very similar to trouble code P0345.

Multiple leaks in main gasket

Hello. If the leaks are coming from where the engine and the transmission come together then you have a rear main seal leaking or a front pump seal in the transmission. The transmission needs to be removed in order to...

My trucks temperature gauge went up and won't start now

This truck has no carburetor. If there is a problem with spark, sometimes you will be able to smell fuel from the exhaust while the engine is turning over and failing to start. If so, there is some fuel making...

4l60e transmission runs fine until engine warms up then loss of all gears and metal on metal noise from bell housing. What do I do

Hi Mike. Anytime you hear metal to metal coming from inside the bell housing of an automatic transmission, that's typically an indication of damage to the torque converter or flywheel. With 300,000+ miles on your Silverado, it's probably time to...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com