Mercedes-Benz GLE350 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(30)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(30)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Mercedes-Benz GLE350 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2018 Mercedes-Benz GLE350V6-3.5LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2022 Mercedes-Benz GLE350L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2016 Mercedes-Benz GLE350V6-3.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2017 Mercedes-Benz GLE350V6-3.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2021 Mercedes-Benz GLE350L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2020 Mercedes-Benz GLE350L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Mercedes-Benz GLE350 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(30)

Rating Summary
29
0
0
1
0
29
0
0
1
0

Peter

28 years of experience
534 reviews
Peter
28 years of experience
Mercedes-Benz GLE350 V6-3.5L - Brake Pads Replacement (Rear) - Simi Valley, California
On time and professional. Thank you.

Joseph

29 years of experience
25 reviews
Joseph
29 years of experience
Mercedes-Benz GLE350 V6-3.5L - Oil Change - Elk Grove, California
Very easy to deal with.Neat,knowledgeable, would recommend Joe to anyone

Brock

32 years of experience
50 reviews
Brock
32 years of experience
Mercedes-Benz GLE350 V6-3.5L - Car is not starting - Gilroy, California
Nice person. sorry I no give you tip today because..........

Ramon

7 years of experience
130 reviews
Ramon
7 years of experience
Mercedes-Benz GLE350 V6-3.5L - Car Battery Replacement - Los Angeles, California
Ramon was friendly and professional - I was very happy with the service and experience! I could tell he’d been doing this for some time, and I enjoyed learning a few things about my car too!

Excellent Rating

(30)

Rating Summary
29
0
0
1
0
29
0
0
1
0
Number of Mercedes-Benz GLE350 services completed
330+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

How to Clean Cylinder Heads
The The engine cylinder head (https://www.yourmechanic.com/article/how-to-buy-a-good-quality-cylinder-head) has many passages for coolant and oil and can build up dirt over the life of the engine. Once the cylinder head is removed from the vehicle, it becomes a simple matter to clean...
P0546 OBD-II Trouble Code: Exhaust Gas Temperature Sensor Circuit High Bank 1 Sensor 1
P0546 code means that the malfunction is related to the exhaust gas temperature sensor circuit due to loose terminals, wiring issues, or faulty sensor
10 Best Stores to Buy Auto Parts in Oklahoma City, Oklahoma
Automotive technicians rely on auto parts stores to add and replace car parts. The best auto parts shop in Oklahoma City is O’Reilly Auto Parts.

Cost to restore the tires to original setting

The cost to restore your suspension to stock condition can vary greatly. Your geographical location can affect parts pricing and availability, labor costs, etc. The most accurate way to price this would be to have the vehicle inspected by one...

Rear liftgate wont close

I would recommend trying to use the unlock switch on your keyfob or door panel. If this does not work, I would recommend inserting your key into the liftgate and turn it to the unlock position. If this does not...

Timing belt ripped Mercedes benz e500 w211 2005

I think what your referring to as the timing belt is the serpentine drive belt (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement). It's the belt that runs all the accessories on the front of the engine. Power steering, Air conditioning, alternator are all driven by this...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com