BMW 228i xDrive Car Battery Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(363)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(363)

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a BMW 228i xDrive Car Battery Replacement is $353 with $258 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2016 BMW 228i xDriveL4-2.0L TurboService typeCar Battery ReplacementEstimate$630.79Shop/Dealer Price$777.24 - $1177.22
2015 BMW 228i xDriveL4-2.0L TurboService typeCar Battery ReplacementEstimate$610.79Shop/Dealer Price$757.27 - $1157.27
Show example BMW 228i xDrive Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

  • Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
  • Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
  • Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

  • A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
  • The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
  • Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
  • The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
  • Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
  • The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

  • The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
  • Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
  • Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
  • Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert BMW mechanics

Real customer reviews from BMW owners like you.

Excellent Rating

(363)

Rating Summary
352
5
4
2
0
352
5
4
2
0

Damian

11 years of experience
465 reviews
Damian
11 years of experience
BMW 228i xDrive L4-2.0L Turbo - Oil Change - Kensington, Maryland
Damian showed up early to my appointment. He was courteous and friendly.

Behrak

9 years of experience
321 reviews
Behrak
9 years of experience
BMW 228i xDrive L4-2.0L Turbo - Oil Change - Duluth, Georgia
Great first experience - will definitely use again!

Jimmi

27 years of experience
231 reviews
Jimmi
27 years of experience
BMW 228i xDrive L4-2.0L Turbo - Brake Rotor/Disc Replacement (Rear) - Sanford, Florida
I will only work with Jimmi. Honest mechanic and quality work.

Joel

21 years of experience
987 reviews
Joel
21 years of experience
BMW 535i L6-3.0L Turbo - Battery - Jacksonville Beach, Florida
Great experience.

Excellent Rating

(363)

Rating Summary
352
5
4
2
0
352
5
4
2
0
Number of BMW Car Battery Replacement services completed
3993+
services done by our mechanics
TOTAL NUMBER OF EXPERT BMW MECHANICS
1100+
experts on our platform

Recent articles & questions

How to Install a Car Volt Amp Gauge
When When you think about the number of sensors (https://www.yourmechanic.com/article/what-sensors-do-all-cars-have-and-what-optional-ones-are-there) that your engine has, it seems like there is an endless amount of gauges that can be installed to monitor their readings. Some of these readings are important, but many...
P2317 OBD-II Trouble Code: Ignition Coil F Secondary Circuit
P2317 P2317 code definition Ignition coil F secondary circuit What the P2317 code means This trouble code indicates that the powertrain control module has detected an abnormal reference voltage from the one of the engine’s ignition coils. What are the...
B1974 OBD-II Trouble Code: Passenger’s Seat Recline Forward Switch Circuit Short to Battery
B1974 means there is an issue with the recline forward seat button on the passenger side, likely due to damaged electrical components in the system.

Power seat stuck forward

Hi there. If your power seat is not working it can be 1 of 2 things. Firstly, this can be an issue with the fuse that is connected inline for the power seats to work. Secondly, it can be your...

Can't reverse

I will assume the transmission does transfer power in the other drive gears. The electronically controlled transmission may have a failed solenoid that directs fluid pressure to the reverse gear assembly. In most cases, the transmission is removed and overhauled...

Breaks

If your brake pedal is going to the floor and you are not losing any brake fluid from a leak then the problem is inside the master cylinder and will need to be replaced and system bleeding of air after...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com