Showing articles & questions for topic
V10-8.0L

Related questions

Question
Having problems with replacing the valve body.
Try to keep in mind the position of the park rod when you first removed the valve body. As long as nothing else was changed between removing the valve body and reinstalling it, the valve body should go back in...
Question
94 to 96 V10 swap, what needs to be changed?
This is not a simple question since the engines are a couple years apart. Each and every sensor and injector may be different. Just by looking at a wiring diagram the two engines are very different. You may have to...
Question
will crank but wont start
Ill try to answer this without getting too technical. Your vehicle uses two network communication circuits, called busses, to communicate with all the different modules. Like any circuit, it requires a complete path with no breaks to operate. It is...
Question
Gasser to diesel?
Hi there, thanks for writing in your question. As with any project, anything is possible with the right amount of money, patience, and time. I have seen a few of these conversions done, and there are kits out on the...
Question
Loss of power
Hello. From my experience with this truck this is usually caused by a wiring issue on that side of the engine. If the ground loses connection then one side of the engine will begin to misfire and this will occur....
Question
What is the difference between a pinion seal and a pinion flange?
Hello there, thanks for your question. The pinion flange is a part of the rear differential housing that the driveshaft bolts to. The other end is attached to the pinion gear inside of the differential. The pinion seal is what...
Question
1998 dodge viper gts letting of throttle rpm hang 2100 for about 10 to 15 seconds then drop to 700 where it should be.
Hi there. Check the engine for any vacuum leaks. Check all of the vacuum lines to the engine and the brake booster. If there is no vacuum leak, then check the idle air control valve (IAC) and see if it's...
Question
Okay, I have a '99 Dodge Ram 2500 w/8.0 V10. The timing chain needs to be replaced. Should I replace the gears also?
Hi there. When changing out the timing chains, it is recommended to replace all the sprockets. The sprockets are worn into the old chains and can cause the new chains to prematurely fail or stretch. You can use a tensioner...
Question
Timing chain gears.
There are several parts that will need to be changed when doing a timing chain replacement. Typically, you will need to replace the chain, the timing gears, and any guides or tensioners that are associated with the timing chain. Also,...

Need a mechanic?

Our certified mobile mechanics make house calls in over 700 U.S. cities. Fast, free online quotes for your car repair.

Get a quote

Post a question and get free advice from our certified mechanics.


Ask a question