Showing articles & questions for topic
P0018

Sensor output has to be directly tested (or the data/waveform viewed on a scanner) and determined to be faulty prior to replacement. If the sensor happens to test good then, the cause lies elsewhere. Code P0018 (https://www.yourmechanic.com/article/p0018-obd-ii-trouble-code-crankshaft-position-camshaft-position-correlation-bank-2-sensor-a-by-jay-safford) can set due...

Hi there. Locate the crankshaft position sensor and check for power to it with the key on. If there is power, then with using a paper clip to back probe the wiring with the plug installed on the sensor, check...

The gap between the 6K and the 7K line is considered the red zone. This zone is marked as the over-revving speed for the engine as the valves cannot shut any faster and the timing chain creates too much slack...

Hi there. Fault P0018 after a timing belt replacement generally indicates that at least 1 cam is off timing, usually by one one tooth if the engine still runs well. The correlation fault is saying that the crankshaft position in...