1. Home
  2. Advice
  3. Tags
  4. 1967

Showing articles & questions for topic
1967

Related questions

Question
Need help rewiring engine
The simplest and most cost effective way to do this is to purchase a complete wiring harness. Replacing all the wiring one wire at a time or building your own harness is far more time consuming. If you are paying...
Question
The driver's side block is getting hotter than the other side
Hi and thank you for contacting YourMechanic. Most likely what is happening here is that the water jacket in your engine on the right side is obstructed and not allowing sufficient coolant to circulate causing the left side to become...
Question
Buick odd fire. Hot on one side
Hi there. This could be a timing issue with the ignition retarded. The cylinders are getting too hot with the timing out of adjustment. Try advancing the timing. If you are unable to advance the timing, then you will need...
Question
Car won't start, but is turning over
If you are getting spark and fuel to the engine then you may have a timing issue or compression issue. First bring the engine number one cylinder up on compression stroke and then recheck the distributor is not indexed wrong....
Question
Which GM pick up rear end has posi, disc brakes and will match my 67 measurements?
Hi there. The axle from a 2001 Chevrolet Camaro should fit your 67 GMC. The axle is about the width of your original axle and it has disc brakes with the posi loc traction control in the differential. If you...
Question
My driveshaft is welded and not balanced. How much will it costs to replace it.
Hello. You will need to have your driveshaft built properly. It needs to be removed and taken to a driveshaft specialist who can build it to the proper length and balance it. Using a transmission specialist is the best way...
Question
How do I get my car home? My truck does not have a big enough trailer
You could get a car transport to pick up the vehicle and bring it to you. However, if the car is not running and able to drive to get it on a transport then you will most likely need to...
Question
A fuse kills the battery when it is left in.
It is difficult to answer without knowing whether this is a factory courtesy light. If in fact it is, the ground control side of the light should be a part of the dash light dimmer switch. This switch is an...
Question
Strange braking issue.
Hello, based off the information (1967) not sure if that is the correct year. For the year of 1967 it would be an air issue and possible brake (pads or shoes) surface (wear or contaminated) such as oil on brake...
Question
Oil filter
If the vehicle has been sitting or hardly used for three years then I would recommend replacing the filter anytime the oil is changed. The filter is still three years old being soaked in oil and should be replaced. ...
Question
67 mustang was finicky about starting so I replaced alternator and fuel pump but now it won't start
You seem to be indicating that the starter motor turns but the pinion gear is not engaging the flywheel. That means the pinion gear throwout assembly has a fault. You could try disassembling the starter to diagnose that issue or...
Question
My 67 mustang had issues starting so I changed the alternator and fuel pump. Now it won't start.
Hi there. Check all of the wiring form the charging system to the starting system. Make sure that all of the wires are tight and make sure that all of the cables have no green corrosion on them. Since you...
Question
New starter, solenoid, and voltage regulator but starter just spins and doesn't crank the flywheel
If you hear the starter engage but does not turn the motor the flywheel on the engine may have missing teeth. The starter also may have a a bad drive then will not turn the motor. The starter will have...
Question
Clicking sound
What you are describing sounds like a faulty starter solenoid. The starter solenoid is located on the starter and has internal electrical contacts that transmit electricity to the starter. As electricity is supplied to the starter a small gear comes...
Question
What oil should I use in my 67 Jaguar 3.4
The oil used in this motor is 10w30 or 10w40. Use the thinner oil in colder weather and the thicker oil in warmer weather.
Question
'67 Mustang repair estimate
Hi there. Thanks for writing in today to our Ask a Mechanic Q & A. The best way to receive an accurate estimate for the services you require on your 1967 Mustang is to click this link where all of...
Question
My 67 mustang is not moving forward. I need to push it in the garage. The e brake is released. How can I get in forward 8 feet?
The brakes may be seized. The least costly approach will be to take the wheel off and see if the brakes are rusted shut. Of course, another possibility is the wheel bearing(s) could be seized. There are low profile wheel/tires...
Question
Dash circuit board not working correctly.
This may be related to a short, a faulty gauge cluster or a faulty instrument cluster voltage regulator. The instrument voltage regulator regulates the voltage supplied to the various gauges in your vehicle’s dash. When this is not working properly,...
Question
I can't figure out how to change the antenna on my 1967 Chevy PU. Am I missing and easy trick, or is this a major undertaking?
Hi there. It is actually pretty simple to replace the antenna on late 1960's early 70's Chevrolet pick-ups. I would suggest, if you don't already have one, to purchase a service and repair manual, as believe it or not, the...
Question
New clutch assembly now clutch pedal goes down all the way but won't fully disengage, can't change gears.
Hi there. Either the shop did not properly hook up the clutch pedal or they did not adjust it. Take a look at the clutch cable or rod, which ever your vehicle has. Then adjust the clutch pedal where there...

Need a mechanic?

Our certified mobile mechanics make house calls in over 700 U.S. cities. Fast, free online quotes for your car repair.

Get a quote

Post a question and get free advice from our certified mechanics.


Ask a question