Toyota 4Runner Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(1,134)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(1,134)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Toyota 4Runner Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1990 Toyota 4RunnerV6-3.0LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1993 Toyota 4RunnerL4-2.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2013 Toyota 4RunnerV6-4.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2021 Toyota 4RunnerV6-4.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2008 Toyota 4RunnerV8-4.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1996 Toyota 4RunnerL4-2.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2002 Toyota 4RunnerV6-3.4LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1987 Toyota 4RunnerL4-2.4L TurboService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Toyota 4Runner Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Toyota mechanics

Real customer reviews from Toyota owners like you.

Excellent Rating

(1,134)

Rating Summary
1,069
45
7
3
10
1,069
45
7
3
10

Jeff

33 years of experience
441 reviews
Jeff
33 years of experience
Toyota 4Runner L4-2.7L - Car starts and then dies - Folsom, California
Jeff is very professional and knowledgeable. He is very personable and is a people person very kind and does whatever he can to get the job done right and as fast as possible.

Peter

43 years of experience
1321 reviews
Peter
43 years of experience
Toyota 4Runner V6-3.0L - Expansion Valve (Orifice Tube) - Glendale, Arizona
Being in the A/C business myself for over 30 years had a lot of knowledge myself so it was easy to know Peter had a wealth of knowledge. So most people unless they had at least some knowledge of the field would have trouble knowing if a person really knew what he was talking about, but since my past was in the same field you can be assured he impressed me.

Brian

18 years of experience
109 reviews
Brian
18 years of experience
Toyota 4Runner V6-3.4L - Brake Pads Replacement (Rear) - Stone Mountain, Georgia
Great

William

30 years of experience
49 reviews
William
30 years of experience
Toyota 4Runner V6-3.4L - Car is not starting - Peoria, Arizona
Awesome! Tech was polite, efficient and explained everything to us as he worked. Definitely using him again.

Excellent Rating

(1,134)

Rating Summary
1,069
45
7
3
10
1,069
45
7
3
10
Number of Toyota 4Runner services completed
12474+
services done by our mechanics
TOTAL NUMBER OF EXPERT Toyota MECHANICS
1600+
experts on our platform

Recent articles & questions

How to Replace a Lost or Stolen Car Title in Alaska
The The title to your vehicle is an incredibly important document. You’ll need it in order to register your car if you move to another state, but you’ll also need it if you ever decide to sell the car. If...
What are the Car Pool Rules in Maine?
More More and more car pool lanes are popping up all over the country, as various states and counties adopt the notion of having a special lane for carpoolers. In car pool lanes (also known as HOV or High Occupancy...
How to Use the OnStar RemoteLink App on Your Smart Phone
OnStar is a driver-assist tool built into many GM vehicles. The OnStar RemoteLink app for smart phones allows drivers to find places or unlock doors.

Advice on what type of service to do on a car before a road trip

My advice is to stick to one type of oil. In my old cars, I've been using Castrol GTX forever. It's normal and it's not synthetic. I've never had a problem with it, they don't burn out oil and they...

Cracking/popping sound in driver dashboard area - 2013 Jeep Compass

Hi there. The noise heard and the sluggish A/C may be related. It is fairly common for an air distribution actuator to fail. These actuators change positions of doors in the HVAC (heating, ventilation, air conditioning) distribution housing. Typically, a...

98 mazda b2500 steering wheel was locked. I turned key and wheel and it came loose. now truck don't do anything. battery is fine.

You're not imagining it. The ignition switch is made up of two parts, the lock assembly which handles the job of locking the steering column, and the switch element which does the electrical work. The switch element is made of...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com