Suzuki SX4 Brake Drum Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Brake Drum Replacement Service

How much does a Brake Drum Replacement cost?

On average, the cost for a Suzuki SX4 Brake Drum Replacement is $358 with $197 for parts and $161 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
2009 Suzuki SX4L4-2.0L	Service typeBrake Drum Replacement	Estimate$761.31	Shop/Dealer Price$891.65 - $1210.66
2011 Suzuki SX4L4-2.0L	Service typeBrake Drum Replacement	Estimate$697.31	Shop/Dealer Price$827.70 - $1146.76
2010 Suzuki SX4L4-2.0L	Service typeBrake Drum Replacement	Estimate$697.31	Shop/Dealer Price$827.70 - $1146.75
2008 Suzuki SX4L4-2.0L	Service typeBrake Drum Replacement	Estimate$697.31	Shop/Dealer Price$827.63 - $1146.62
2013 Suzuki SX4L4-2.0L	Service typeBrake Drum Replacement	Estimate$1142.72	Shop/Dealer Price$1405.09 - $2153.81
2007 Suzuki SX4L4-2.0L	Service typeBrake Drum Replacement	Estimate$687.81	Shop/Dealer Price$817.20 - $1135.49
2012 Suzuki SX4L4-2.0L	Service typeBrake Drum Replacement	Estimate$905.59	Shop/Dealer Price$1083.61 - $1546.54

Show example Suzuki SX4 Brake Drum Replacement prices

What are brake drums and how do they work?

A brake drum is a heavy, cast iron brake system part that looks like a shallow, several inches-high cylinder about 9 to 12 inches in diameter. The brake drum has a precisely machined surface all around the interior circumference, that the brake shoes make contact with when you apply the brakes, transmitting hydraulic pressure through the wheel cylinder. This forces the brake shoes outward against the interior of the brake drum, resulting in the friction that causes the car to slow. The brake drum is mounted over, and fully encloses, all of the rear brake components such as the wheel cylinder, springs and clips, brake shoes, and parking brake mechanism. The drum is commonly held to the wheel hub by the wheel and the lug nuts, but some configurations combine the drum with the wheel hub as one unit. Nowadays, a drum brake type system is only installed on the rear axle, if used at all, as 4 wheel disc type systems have become more common.

When to consider replacing brake drums:

Reduced braking effectiveness. If the brake drum is unevenly worn, scored or cracked, it will increase stopping distances. A cracked drum must be replaced outright but a worn drum can be restored on a brake lathe so long as enough metal material remains.
Pulsating brakes, pulling to one side, vibration or noise. If a brake drum is warped, is unevenly worn, or perhaps the brake shoes have worn down completely — creating metal-to-metal contact — you might detect pedal pulsation, the vehicle may pull to one side, or you might feel a vibration or hear a noise when you apply the brakes. The brake system will have to be inspected to pinpoint the exact problem.
Brake shoe replacement. Anytime the brake shoes are replaced, the drum must either be resurfaced or replaced outright. Installing new brake shoes on a used, unresurfaced drum will lead to poor results.
Loss of parking brake function. The parking brake locks the brake shoes against the brake drum. If the brake drum is cracked, the parking brake lever will pull up excessively and the car may still be able to roll. However, a more common circumstance is parking brake maladjustment or seizure of parking brake components. Repair of those problems will often require removal of the brake drum.

How do mechanics replace brake drums?

There are two options when it comes to brake drum service: outright replacement or resurfacing. In some cases, it is cheaper to replace the drum rather than refurbish it. In both cases though, the removal and installation procedure for the drum is the same.

Raise the vehicle and safely support it using steel jack stands.
Remove tire and wheel assembly.
Remove brake drum. Sometimes the brake drum has rusted to the wheel hub and removal of the drum will require a brake drum puller. In some cases, the wheel hub is integral to the brake drum, in which case the hub-bearing retaining bolt and the wheel bearing must be removed to replace the drum.
Measure the interior diameter of the machined surface in the drum with a brake drum micrometer or similar measuring tool. If sufficient metal exists to resurface the drum on a brake lathe, the mechanic will compare the cost of such restoration to the alternative: buying a new drum.
Prior to installing the resurfaced or new drum, the brake shoes, springs, wheel cylinder, parking brake mechanism, and backing plate are all inspected. All worn parts should be replaced. Generally, if drums have been replaced or resurfaced, new brake shoes should be installed. The worn shoes will cause irregular wear in the brake drum and reduce braking effectiveness.
The shoes are adjusted and the drum is installed. The wheel and tire assembly are installed and torqued in the proper sequence and the car is road tested to check the operation of the brakes.

Is it safe to drive with a brake drum problem?

No. Should there be a deficiency with the brake drums, stopping distances will not be as short as possible. In a panic stop, stopping just five or ten feet shorter could be the difference between no collision and a collision. Any deficiency in a vehicle’s braking system is a cause for concern and a potential safety issue. Have the brake drums inspected at your earliest convenience to determine if a problem exists and find out what must be done to fix it.

When replacing brake drums keep in mind:

With few exceptions, brake work on one end of an axle should be performed on both ends of the axle. Should a brake drum on one end of a front or rear axle be serviced, or brake shoes on one end are serviced, both sides of the axle should receive the same service. This helps to avoid problems, such as pulling, vibration, and so forth, once the vehicle is returned for use.
Brake drum systems use very powerful springs to keep the brake shoes in position. These springs are exposed to extreme heat. It is best practice to replace all springs whenever new shoes are installed. Should a spring unexpectedly break in the brake drum assembly, a mispositioned brake shoe could cause the brakes to grab and lock, which would pose a safety issue.
If the wheel hub and bearing are integral to the brake drum on your car, the mechanic may recommend replacement of the grease in the wheel bearings and inspection of the wheel bearings.
Since the arc of the brake shoes will not perfectly match with the arc of the drum when new, expect a bed-in period before maximum braking efficiency is achieved.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Suzuki mechanics

Real customer reviews from Suzuki owners like you.

Excellent Rating

(62)

Rating Summary

59

2

1

0

0

59

2

1

0

0

SEE REVIEWS NEAR ME

Chris

22 years of experience

2223 reviews

Chris

22 years of experience

by Heather

Suzuki SX4 L4-2.0L - Water Pump - Huntington Beach, California

Fixed my car right up. After he was done he showed me how to keep up with it and to add more coolant when necessary. Very helpful.

Jamahl

20 years of experience

830 reviews

Jamahl

20 years of experience

by Jonathan

Suzuki SX4 L4-2.0L - Brake Pads Replacement (Front) - Orlando, Florida

Fantastic experience as usual!

Clarissa

27 years of experience

234 reviews

Request Clarissa

Clarissa

27 years of experience

Request Clarissa

by Kalpana

Suzuki SX4 L4-2.0L - Spark Plugs - Spring City, Pennsylvania

First time we used Yourmechanic.com and it was a great experience! Clarissa was on time, explained everything and did great work. Definitely will be using this service again, specifically because of Clarissa's excellent work and customer care.

Theodore

16 years of experience

1587 reviews

Request Theodore

Theodore

16 years of experience

Request Theodore

by Millie

Suzuki SX4 L4-2.0L - Door will not open - Kirkland, Washington

Theodore repaired the inner right side rear door. He also checked the fluid levels and tire pressure.

Excellent Rating

(62)

Rating Summary

59

2

1

0

0

59

2

1

0

0

SEE REVIEWS NEAR ME

Recent articles & questions

A Buyer’s Guide to the 2012 BMW 1-Series

The The 2012 BMW 1-Series, which includes both the 128i and the 135i in both a coupe and convertible options, provides the perfect combination of power, performance and luxury. Designed with a focus on thrilling acceleration and a smooth, elegant...

How Long Does a Throttle Controller Last?

In In order for your accelerator pedal to actually work as you push down on it, it needs to be connected to the throttle. In older model vehicles there was a mechanical link that connected the throttle body and the...

How to Replace a Lost or Stolen Car Title in Florida

Without Without your car’s title, you cannot register it in Florida, or in another state if you’re moving out of Florida. In addition, you can’t sell it, trade it in, or use it as collateral for a loan. Obviously, this...

Car shakes and stutters during acceleration - 2001 Toyota Echo

As I was reading this I was thinking spark plugs, but you said there was a couple CENTIMETERS of translucent yellow oil? I can't even imagine what must be happening inside the engine to completely cover spark plugs. I would...

Fuel pump will only run for a few seconds and the car dies.

Hi there. When the fuel pump will only run for a few seconds, it's typically caused by an electrical short or failure with the fuel pump relay. This situation can also occur if there is an obstruction of debris in...

valve cover replacement, chevy cruze LS 2011, the light was on, but then I don't see it anymore

What exactly was wrong with the "valve cover"? Valve covers are not typically replaced unless the cover is cracked or deformed. On cars, the check engine light can, occasionally, come on, stay awhile and then disappear never to be seen...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com