Saturn Ion Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(275)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(275)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Saturn Ion Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2005 Saturn IonL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2003 Saturn IonL4-2.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2006 Saturn IonL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2007 Saturn IonL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2004 Saturn IonL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2006 Saturn IonL4-2.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2006 Saturn IonL4-2.4LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2007 Saturn IonL4-2.2LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Saturn Ion Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Saturn mechanics

Real customer reviews from Saturn owners like you.

Excellent Rating

(275)

Rating Summary
255
9
2
3
6
255
9
2
3
6

Jay

16 years of experience
40 reviews
Jay
16 years of experience
Saturn Ion L4-2.2L - Car starts and then dies - West Palm Beach, Florida
Great guy, showed up early and helped me with my issue!

Benji

22 years of experience
277 reviews
Benji
22 years of experience
Saturn Ion L4-2.2L - Adjust Drum Brakes - Chandler, Arizona
Knowledgeable professional

Christopher

27 years of experience
347 reviews
Christopher
27 years of experience
Saturn Ion L4-2.2L - Tire Rotation - Wethersfield, Connecticut
Very nice and super helpful! We had to push back first appointment due to rain (understandable). I had moved out of his area, but Chris was still more than willing to come to me! I will always use Chris as long as I am in Ct.

Scott

34 years of experience
548 reviews
Scott
34 years of experience
Saturn Ion L4-2.2L - Battery - Denver, Colorado
Scott called when he was on his way. When he got here, he explained that I could wait in my apartment. When he was done he called. He explained everything that he found and did . He was extremely polite and personable. I would recommend him to anyone who needs a mechanic.

Excellent Rating

(275)

Rating Summary
255
9
2
3
6
255
9
2
3
6
Number of Saturn Ion services completed
3025+
services done by our mechanics
TOTAL NUMBER OF EXPERT Saturn MECHANICS
700+
experts on our platform

Recent articles & questions

A Buyer’s Guide to the 2012 Mitsubishi Galant
If If you’re in the market for a midsize sedan and want the best price possible, you may be thinking about visiting a Honda or Toyota dealership. Before you do, check out the 2012 Mitsubishi Galant. Key Features Considering how...
How to Buy a Good Quality Floor Console
A A floor console, which can also be called a center console, is an accessory you can purchase that sits on the floor of your vehicle and offers storage and organization space. It can be used to replace an existing...
P0147 OBD-II Trouble Code: O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 3)
P0147 P0147 code definition O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 3) What the P0147 code means P0147 is the OBD-II generic code indicating the Engine Control Module (ECM) has tested the O2 sensor heater circuit during startup and...

broke belt, replaced belt, now car will turn over but will not crank

Check the lower left side of the engine to check to see if the crankshaft speed sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) was damaged when the belt was broke or when the new one was replaced. It has two wires and a connector. The...

I was going through the undercarriage wash at carswash n my f150 shut off...i could start itup right away again it showed low oil

Since the vehicle stalled it would display the low oil pressure until you started it back up. The fact that the outside temperature is so cold and the water hot it could of got into a wire connector that caused...

I got my fixed but the car is still overheating and the heat not working and was leaking coolant

The lack of heat being generated by your system may indicate a clogged or leaking heater core. The heater core (https://www.yourmechanic.com/services/heater-is-not-working-inspection) is a small radiator like unit that circulates the hot coolant from the engine through the heater core which...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com