Plymouth Breeze Engine is misfiring Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(6)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(6)

Engine is misfiring Inspection Service

How much does a Engine is misfiring Inspection cost?

On average, the cost for a Plymouth Breeze Engine is misfiring Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1997 Plymouth BreezeL4-2.0LService typeEngine is misfiring InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1999 Plymouth BreezeL4-2.0LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1998 Plymouth BreezeL4-2.0LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1997 Plymouth BreezeL4-2.4LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1999 Plymouth BreezeL4-2.4LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2000 Plymouth BreezeL4-2.0LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1996 Plymouth BreezeL4-2.0LService typeEngine is misfiring InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2000 Plymouth BreezeL4-2.4LService typeEngine is misfiring InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Plymouth Breeze Engine is misfiring Inspection prices

When an engines misfires, it’s usually readily apparent to the driver from the stuttering and jerking produced by the engine when one or more cylinders fails to fire properly, either because of ignition- or fuel-related issues. It is accompanied by a loss of power in direct proportion to the severity of the misfire.

It can be tricky for to track down the problem if the misfire only occurs under certain circumstances, for example, under load. Not all misfires occur across the operating spectrum.

For older vehicles:

On older, carbureted vehicles, the culprit will almost certainly be in the ignition system as older vehicles lack many of the sophisticated sensors that can cause a misfire. A vacuum leak or a faulty fuel pump can also cause this symptom as well. The first thing the mechanic will do is determine which cylinder or cylinders is misfiring, and the spark plug color is probably the best way to tell. The guilty plug will most likely be grayer than the others, which should tend toward brown coloring. If needed, the spark plug can be replaced.

The next step would be checking the wiring to that plug for cracks and deterioration, and replace as necessary.

For most modern vehicles:

In modern cars, misfiring will invariably be accompanied by a Check Engine light. In fact, checking for efficient combustion was the primary reason the U.S. government introduced the rules for OBD-II (on-board diagnostics, second generation). It was part of the push toward cleaner exhaust emissions.

A code reader will tell you which cylinder is to blame, but it may not say whether it is a problem relating to the injector serving that cylinder or the systems delivering the ignition spark. As with older vehicles, a look at the wires and spark plugs is a good idea. Checking them in the dark will sometimes reveal errant spark tracking, as will spraying them with a fine water mist.

One way mechanics check which spark plug is failing to hold its own is by running the engine at an idle speed high enough to produce the misfire, then removing leads from the coilpack (the unit that looks like the distributor we are used to seeing in older vehicles ) one by one. Most removals will cause a profound change in idling performance, but a defective wire will not. That will suggest that it’s either the spark plug or the coil serving that cylinder at fault. If a new spark plug at that cylinder does not remove the stumble, the mechanic may need to replace the coil pack or the wires as a set.

If it isn’t an ignition issue, then the injectors will need to be checked. A mechanic uses a multimeter to check the resistance value at each injector. It may be a bit difficult to reach them, sometimes requiring the removal of an engine cover and the intake manifold. The mechanic disconnects the injector, then touches the multimeter probes to the two connector prongs to read the value, in Ohms. If any of the injectors read outside of the specified values, they will need to be replaced.

Along the same lines, a fuel pump starting to go bad can also cause misfires or similar issues and can be diagnosed with a fuel pressure check of the entire system with the appropriate equipment. This should only be done by a qualified mechanic as the fuel system is highly pressurized and of course, fuel is flammable.

Common reasons for this to happen:

  • Faulty spark plugs or wires
  • Faulty ignition coil
  • Broken piston rings
  • Burnt or bent valves
  • Broken valve springs
  • Camshaft worn out
  • Fuel injector is not working

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the misfiring engine, and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How important is this service?

A misfiring engine is accompanied by a loss of power, which makes this issue a critical one to correct promptly. Book a mechanic to perform a thorough inspection as soon as possible.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Plymouth mechanics

Real customer reviews from Plymouth owners like you.

Excellent Rating

(6)

Rating Summary
5
0
0
0
1
5
0
0
0
1

Ricardo

23 years of experience
199 reviews
Ricardo
23 years of experience
Plymouth Breeze L4-2.4L - Brake Pads Replacement (Front) - Homestead, Florida
Very professional. Made my day after weeks of anxiety.

Joshua

27 years of experience
709 reviews
Joshua
27 years of experience
Plymouth Breeze L4-2.4L - Timing Belt - Oakland, California
Very experienced and thorough

Joshua

27 years of experience
709 reviews
Joshua
27 years of experience
Plymouth Breeze L4-2.0L - Car starts and then dies - Clayton, California
Outstanding mechanic

Melvin

14 years of experience
158 reviews
Melvin
14 years of experience
Plymouth Breeze L4-2.4L - Alternator - Virginia Beach, Virginia
Great first impression, very friendly, professional and knowledgeable, did a very good job, he will be my mechanic from now on.

Excellent Rating

(6)

Rating Summary
5
0
0
0
1
5
0
0
0
1
Number of Plymouth Breeze services completed
66+
services done by our mechanics
TOTAL NUMBER OF EXPERT Plymouth MECHANICS
100+
experts on our platform

Recent articles & questions

Top 10 Scenic Drives in Utah
Utah is a state with a landscape not quite like any other that varies widely from place to place. At times, travelers find desert expanses that periodically turn into scenes that seem plucked from an abstract work of art with...
Symptoms of a Bad or Failing AC Condenser
If your AC is cooling your car significantly less than usual or there are leaks from the AC system, you may need to replace your AC condenser.
P0503 OBD-II Trouble Code: Vehicle Speed Sensor Intermittent/Erratic/High
P0503 P0503 code definition Vehicle Speed Sensor Intermittent/Erratic/High What the P0503 code means The P0503 code indicates that the Engine Control Module (ECM) has detected an inconsistent signal voltage from the vehicle speed sensor. What are the causes of the...

Truck won't crank

From your description, it sounds as though your ignition switch is faulty. If there is power on the wire when trying to crank, it could be a faulty starter. You could ask for help from a certified mechanic at YourMechanic...

Steering lock malfunction and key wont turn in ignition.

Your key could be stuck for several reasons. Since the steering wheel moves, it's not the steering lock. The first thing to attempt, is to use an electrical cleaner or air duster to remove any debris that may be stuck...

Rough idle

Hi There, It sounds like your car may have a bit of a rough idle problem. There are a number of things that may cause a rough idle. A rough idle (https://www.yourmechanic.com/services/car-idle-is-rough-inspection) may be caused by things such as low...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com