Hyundai Santa Fe XL Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(29)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(29)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Hyundai Santa Fe XL Water Pump Replacement is $437 with $185 for parts and $252 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2015 Hyundai Santa Fe XLV6-3.3LService typeWater Pump ReplacementEstimate$719.16Shop/Dealer Price$835.68 - $1170.66
2017 Hyundai Santa Fe XLV6-3.3LService typeWater Pump ReplacementEstimate$702.94Shop/Dealer Price$816.28 - $1148.88
2014 Hyundai Santa Fe XLV6-3.3LService typeWater Pump ReplacementEstimate$702.94Shop/Dealer Price$816.33 - $1148.96
2016 Hyundai Santa Fe XLV6-3.3LService typeWater Pump ReplacementEstimate$702.94Shop/Dealer Price$816.33 - $1148.95
2013 Hyundai Santa Fe XLV6-3.3LService typeWater Pump ReplacementEstimate$632.84Shop/Dealer Price$731.35 - $1013.40
2018 Hyundai Santa Fe XLV6-3.3LService typeWater Pump ReplacementEstimate$913.41Shop/Dealer Price$1038.27 - $1399.34
Show example Hyundai Santa Fe XL Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Hyundai mechanics

Real customer reviews from Hyundai owners like you.

Excellent Rating

(29)

Rating Summary
26
2
1
0
0
26
2
1
0
0

Mazyar

20 years of experience
587 reviews
Mazyar
20 years of experience
Hyundai Santa Fe XL V6-3.3L - Oil Change - Smyrna, Georgia
Fast and thorough.

Tinashe

14 years of experience
781 reviews
Tinashe
14 years of experience
Hyundai Santa Fe XL V6-3.3L - 30,000 Miles Maintenance Service - Smyrna, Georgia
Courteous and professional

Terry

31 years of experience
223 reviews
Terry
31 years of experience
Hyundai Sonata L4-2.4L - Water Pump - Mesa, Arizona
Great service Thank you

Patrick

34 years of experience
1579 reviews
Patrick
34 years of experience
Hyundai Elantra L4-2.0L - Water Pump - Austin, Texas

Excellent Rating

(29)

Rating Summary
26
2
1
0
0
26
2
1
0
0
Number of Hyundai Water Pump Replacement services completed
319+
services done by our mechanics
TOTAL NUMBER OF EXPERT Hyundai MECHANICS
1300+
experts on our platform

Recent articles & questions

Rules of the Road For North Dakota Drivers
Those Those who have a valid driver’s license have already proven that they know the rules of the road in the state in which they drive. Much of that knowledge, especially the laws that are based on common sense, also...
How to Replace an Exhaust Gas Recirculation (EGR) Temperature Sensor
Exhaust gas recirculation (EGR) temperature sensors monitor the EGR cooler's operation. One is on the exhaust manifold and one is near the EGR valve.
How to Replace a Lost or Stolen Car Title in Alaska
The The title to your vehicle is an incredibly important document. You’ll need it in order to register your car if you move to another state, but you’ll also need it if you ever decide to sell the car. If...

A/C vents not blowing out air

Hello there. This is not an uncommon fault. The AC system uses various doors and motors to control where the AC comes out and the temperature of it. Over time, it is common for the mode selection actuator to fail,...

I've got a P0507 code, what can I do?

Hi there. It sounds like the idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) is stuck at the high idle position. The idle air control valve is located on the throttle body assembly and allows air to bypass the throttle plate to control...

Truck felt like it was slipping on ice and the locks kept locking and unlocking and couldn't drive past 15 mphs and when I accelerated it would jerk. Shut it off and won't turn on and [battery](/topics-battery-gmc/) is dead. And I have a brand new battery in it

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com