Buick LeSabre Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(383)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(383)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Buick LeSabre Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1981 Buick LeSabreV6-3.8LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1960 Buick LeSabreV8-6.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1984 Buick LeSabreV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1974 Buick LeSabreV8-7.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1980 Buick LeSabreV6-4.1LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1984 Buick LeSabreV8-5.7L DieselService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1970 Buick LeSabreV8-7.5LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1964 Buick LeSabreV8-7.0LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Buick LeSabre Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Buick mechanics

Real customer reviews from Buick owners like you.

Excellent Rating

(383)

Rating Summary
352
23
3
2
3
352
23
3
2
3

Robert

20 years of experience
1089 reviews
Robert
20 years of experience
Buick LeSabre V6-3.8L - Car starts and then dies - Denver, Colorado
He was quick and on time, answered all of my questions and told me what was going on with my car. I have booked an appointment for him to service my buick.

Steven

14 years of experience
425 reviews
Steven
14 years of experience
Buick LeSabre V6-3.8L - Car starts and then dies - Avondale, Arizona
Steven was incredibly polite and personable and seemed to give sincere recommendations.

David

10 years of experience
170 reviews
David
10 years of experience
Buick LeSabre V6-3.8L - Car starts and then dies - Orlando, Florida
David is always on time and very professional. he has always diagnosed my problem correctly. He's always been able to repair any problem I've had. He seems to be very honest so I trust the info he gives me about my Vehicles. A-1 Mechanic! Thanks David.

Duane

25 years of experience
510 reviews
Duane
25 years of experience
Buick LeSabre V6-3.8L - Starter - Carlsbad, California
Duane is a great mechanic!

Excellent Rating

(383)

Rating Summary
352
23
3
2
3
352
23
3
2
3
Number of Buick LeSabre services completed
4213+
services done by our mechanics
TOTAL NUMBER OF EXPERT Buick MECHANICS
800+
experts on our platform

Recent articles & questions

How Long Does a Proportioning / Combination Valve Last?
Modern Modern brake systems are far more advanced than they were even a few years ago. Today, most cars come with front disc and rear drum brakes (although many also come with four-wheel disc brakes). In a disc/drum combination system,...
How to Pick an Extended Car Warranty
A A new vehicle comes with a manufacturer’s new car warranty (https://www.yourmechanic.com/article/what-do-manufacturer-warranties-normally-include) that covers defects and unexpected problems that occur. The new vehicle warranty coverage is in place for a set time or mileage, whichever comes first. When the manufacturer’s...
How to Replace the Lateral Link(s) on Most Cars
The suspension system has lateral links which fail when the steering feels loose, there is a noticeable clunking, or wear on the rear tires.

Temperature gauge past 260 degrees

Hello there. There are a few possible reasons why your 1997 Pontiac Trans Sport would have a high temperature gauge reading like this. There are two lines of reason for this problem. Either the gauge is reading high due to...

Do you install timing chain guides on fwd VQ35DE? 2006 Nissan Altima V6

If you can hear the chain whining while you drive, it's time to quit driving the car. If the timing chain breaks while you are going down the road, the damage that will occur will probably mean replacing the engine....

I have a 08 acura Mdx with a code p0389 I put a cam and crank sensor on

Hi Nicholas. Thanks for contacting us today. The P-0389 code (https://www.yourmechanic.com/article/p0389-obd-ii-trouble-code-crankshaft-position-sensor-b-circuit-intermittent) is often caused by a failed electrical harness to the sensor. If the harness was not replaced, or if the code was not cleared from the ECU after completing...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com