Popular questions

Hi Bryan. Thanks for contacting us today. This might be due to a damaged electrical relay or perhaps the battery cables themselves were damaged during the cross-connection. It is also possible that the ECU may have been damaged or other...

The transmission not going into reverse until the transmission fluid warms up is most likely due to leaking internal pressure seals are bypassing fluid until it warms up. This will require the transmission to be rebuilt and all seals replaced...

You need to look under the drivers side of the dash to see if the shifter linkage in the steering column is moving the shift cable. The bolts that hold the bracket to the bottom of the shifter shaft come...

In this situation, especially after the note about the fuel level no changing, I would have the fuel pressure checked first to make sure the fuel pump is actually sending fuel to the engine on the times it will not...

Hello. It is possible that the transmission is faulty and may need to be replaced for your 2007 Chevrolet Express 2500. It sounds like the transmission valve body is overheating and causing the shifting problem you are experiencing. The clutches...

If your master cylinder is not losing fluid and you tried bleeding the system then your master cylinder is bad. The internal rubber cups got damaged when you allowed the pedal to go to the floor the first time. You...

You my have a slipping clutch and should have it checked by a mechanic like one from YourMechanic to see if the clutch needs replaced.

The high mileage oil brand, and the specific viscosity rating (5W-30), that your husband bought for you is perfectly acceptable and you needn't worry at all. High mileage oil simply claims to have "extra" engine oil seal conditioners and perhaps...

When your ABS system detects the wheels are losing contact with the road you will see and feel various braking pulsations, hard pedal as the ABS is trying to help you keep control on the ice. Once the 4 tires...

When vehicle headlights go out, normally a simple fuse or light bulb replacement can correct this issue. However there is a known problem where the headlamp assemblies, sockets and wiring are melting due to high heat and resistance in this...

Generally, a switch assembly from 1989 through 1994 will work on this vehicle, but to get a precise answer if you plug in your vehicle data on-line at Car-Part.com you will get not only all possible interchange years but you...

Before you drive the car again, you need to find the lug wrench and check to be sure that all your wheel lugs are tight You might have one or more loose wheels. If you don't find a problem there,...

The check engine may be blinking due to computer sensor or misfire issue. Have the computer scanned to get the failure codes and then have the codes diagnosed. You may have a lean injection system causing misfire when first started...

Listen for the fuel pump to come on for 2 seconds when you turn the key on. You may have to listen back by the fuel tank. Check for coolant level to be low. You may have a cracked upper...

You may have a failing voltage regulator that could be allowing the alternator to supply too much or too little amperage to the battery resulting in the battery never maintaining a consistent charge as it is designed to. The voltage...

It is possible that the camshaft sensor is the cause of the issue. It is also possible that there could be an issue with the timing or the crankshaft sensor. I would recommend having a qualified professional inspect your vehicle...

If the outer CV joint has popped out, there's a likelihood that it is damaged. It can be examined to determine if it is safely re-usable but the best course will likely be to just replace the axle that has...