Volvo V90 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(5)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(5)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Volvo V90 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2020 Volvo V90L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1998 Volvo V90L6-2.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2021 Volvo V90L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1997 Volvo V90L6-2.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2019 Volvo V90L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2018 Volvo V90L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Volvo V90 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Volvo mechanics

Real customer reviews from Volvo owners like you.

Excellent Rating

(5)

Rating Summary
4
0
1
0
0
4
0
1
0
0

Brandon

18 years of experience
318 reviews
Brandon
18 years of experience
Volvo V90 L6-2.9L - Oil Change - Raleigh, North Carolina
Brandon was awesome. Very knowledgeable about problems and offered great solutions. Definitely recommending my mechanic

Amor

43 years of experience
181 reviews
Amor
43 years of experience
Volvo V90 L6-2.9L - Top off coolant - Palo Alto, California
Didn't initially bring coolant even though job was to top up coolant. Had to leave and come back. But otherwise very smooth.

Matthew

12 years of experience
183 reviews
Matthew
12 years of experience
Volvo XC90 L6-2.9L Turbo - Car starts and then dies - Indianapolis, Indiana
An asset to the company.

James

8 years of experience
128 reviews
James
8 years of experience
Volvo S40 L4-1.9L Turbo - Car starts and then dies - Atlanta, Georgia
Friendly, Professional.

Excellent Rating

(5)

Rating Summary
4
0
1
0
0
4
0
1
0
0
Number of Volvo Car starts and then dies Inspection services completed
55+
services done by our mechanics
TOTAL NUMBER OF EXPERT Volvo MECHANICS
600+
experts on our platform

Recent articles & questions

How Can Problems with the Ignition System Cause Misfiring?
Misfires Misfires are never good, and they're always a sign that there’s a problem with the engine that needs to be repaired. The problem won’t “go away on its own” and waiting too long can cause the situation to grow...
Mississippi Speed Limits, Laws, and Fines
Following Following is an overview of the laws, limits, and fines as they relate to speeding traffic violations in the state of Mississippi. Speed limits in Mississippi In 2008, Mississippi legislators approved a speed limit of up to 80 mph...
How to Ship a Car
It used to be that if you wanted to buy a car you’d head to the nearest auto mall, and spend the day shopping. After a while the cars, dealerships, salespeople, and deals blended together. Who hasn’t made an offer...

steering wheel very stiff even after fluid was added

Hello. There could be a problem with the power steering pump leaking, one of the power steering hoses leaking, or the rack and pinion leaking. Those would be the 3 major culprits that could be causing issues. Have the entire...

ABS light is on.

Your truck is equipped with wheel speed sensors at each of the four wheels which monitor wheel speed while relaying this information constantly to the ABS and traction control system which are controlled by the car's ECU. When the ECU...

My car has been overheating at idle for 4 days. I did some research and decided to replace the thermostat and coolant hoses, and do a coolant flush. On the 4th day I was driving home from a quick trip out and driving up hill. I turned over drive off because it's supposed to be better when going up steep hills. A few blocks later I started smelling burning and my temp gauge was shooting up. I was 2 blocks from home so I just got there and parked it. The next day I checked the coolant and the reservoir was empty. I checked the oil and it was almost black. Last time I checked them was 5 days previous and oil was fine, coolant needed to be topped off in the reservoir but it was only an inch below max. Do you think I might have an internal coolant leak? I don't think it's in the oil because it doesn't have that frothy look. Not sure about the heater core but I'm not noticing any monster in the front passenger area. I havent noticed any coolant leaking externally.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com