Subaru Justy Car Battery Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Subaru Justy Car Battery Replacement is $291 with $151 for parts and $140 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1992 Subaru JustyL3-1.2L	Service typeCar Battery Replacement	Estimate$456.02	Shop/Dealer Price$534.88 - $763.34
1991 Subaru JustyL3-1.2L	Service typeCar Battery Replacement	Estimate$447.01	Shop/Dealer Price$524.10 - $751.24
1995 Subaru JustyL3-1.2L	Service typeCar Battery Replacement	Estimate$465.99	Shop/Dealer Price$547.85 - $789.24
1993 Subaru JustyL3-1.2L	Service typeCar Battery Replacement	Estimate$447.01	Shop/Dealer Price$524.12 - $751.28
1994 Subaru JustyL3-1.2L	Service typeCar Battery Replacement	Estimate$447.01	Shop/Dealer Price$525.60 - $753.86
1990 Subaru JustyL3-1.2L	Service typeCar Battery Replacement	Estimate$447.01	Shop/Dealer Price$524.26 - $751.53

Show example Subaru Justy Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Subaru mechanics

Real customer reviews from Subaru owners like you.

Excellent Rating

(194)

Rating Summary

187

4

1

0

2

187

4

1

0

2

SEE REVIEWS NEAR ME

Harold

33 years of experience

52 reviews

Harold

33 years of experience

by Mark

Subaru Outback H4-2.5L - Battery - Fernandina Beach, Florida

very very good

Robert

21 years of experience

1307 reviews

Robert

21 years of experience

by Phil

Subaru Forester H4-2.5L - Battery - Denver, Colorado

Thank you!

Robert

32 years of experience

646 reviews

Robert

32 years of experience

by Kevin

Subaru Impreza H4-2.0L - Battery - Campbell, California

Came right on time. Quickly identified the problem and got the car up and running in no time.

Lucas

30 years of experience

938 reviews

Lucas

30 years of experience

by April

Subaru Impreza H4-2.0L - Battery - Woodland Hills, California

Friendly and helpful. Arrived on time.

Excellent Rating

(194)

Rating Summary

187

4

1

0

2

187

4

1

0

2

SEE REVIEWS NEAR ME

Recent articles & questions

P2231 OBD-II Trouble Code: O2 Sensor Signal Circuit Shorted to Heater Circuit Bank 1 Sensor 1

P2231 P2231 code definition O2 Sensor Signal Circuit Shorted to Heater Circuit Bank 1 Sensor 1 What the P2231 code means P2231 is an OBD-II generic code for the engine control module (ECM) detecting the O2 sensor signal is shorted...

How to be a Successful Car Salesperson

Admit Admit it. As a car salesperson (https://www.yourmechanic.com/article/how-to-choose-your-car-salesperson-by-patrick-haas), you’ve probably been stereotyped by your customers. And while there may be a few bad salespeople out there, you know that the majority, yourself included, are hardworking and decent. Still, from the...

How Long Does an Automatic Transmission Last?

Be aware of how long your automatic transmission is intended to last and the best practices for extending its life.

Thermostat - 2009 Mercury Milan

Hello there. This is a common issue with your Mercury Milan. If the coolant temperature sensor (https://www.yourmechanic.com/services/coolant-temperature-switch-sensor-replacement) reads improperly, it will set the service engine light and require replacement. This sensor is located in the thermostat housing. You can buy...

rubbing sound when turning right or left and vibration in steering wheel

This is a common sign of a bad or worn wheel bearing (https://www.yourmechanic.com/services/wheel-bearings-replacement). When wheel bearings wear out or become damaged due to dirt or debris or lack of proper amount of grease, they can make a rubbing, grinding or...

What is the cost to replace the tensioner pulley, idler pulley, and the drive belt?

Billing question sent to CS for the cost to replace the tensioner, pulleys, and the drive belts.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com